Minka Group 5043-695 User manual

Minka Group
Brand
Minka Group
Model
5043-695
Type
User manual

This manual is also suitable for

INSTALLATION INSTRUCTIONS
Item#5042/5043-695 (New. 2023/04/14)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Page:1/1
Fig. 1
Fig. 2
LA-3673E
MOUNTING THE FIXTURE (Fig.1)
1. Shut off powe
r at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts
in a clean area. Take care not to misplace any small parts
necessary for installation.
3. Screw rod (I) to all thread (M) on fixture body, then screw
rod (I) to all thread (N) on large shade (F). Pass
the wires
carefully through rod as you assemble.
4. Place large shade (F) on small shade (G
) and secure with
screws (E).
5. Thread screws (A) into pre-drilled holes on crossbar (B)
spaced same distance apart as holes in canopy (D). T
he
length of screws (A) may be adjusted, if necessary.
6.
Attach crossbar (B) to junction box (not included) using
mounting screws (C) (Size: #8-32N*L0.5”). The side of
crossbar (B) marked “GND” must face out.
CONNECTING THE WIRES (Fig. 2)
7. Connect the electrical wires as shown in fig 2, making sure
that all wire connectors are secured. If your junction box
has a ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect the fixture’s
ground wire directly to crossbar (B) using the green screw
provided.
8. Tuck wire connectors neatly into the junction box.
FINISHING THE INSTALLATION (Fig.1)
9. Place canopy (D) over screws (A) and secure with knurl
ed
knobs (H).
10. Place candle covers (K) over sockets (L).
11. Install (5) five candelabra base bulbs (J
) up to 60 watts
each or CFL or LED equivalent (not included)
, in
accordance with the fixture specification—DO NOT
EXCEED THE MAXIMUM WATTAGE RATING! (NE PAS
DEPASSER LA PUISSANCE NOMINALE MAXIMALE!).
Your installation is now complete. Return power
to the
junction box and test the fixture.
identical to the fixture purchased.
Set
#
A
-
0
10
-Crossbar
-Ground screw
-Mounting screws*2
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Candle cover#CCV21051P-695
F
N
G
A
B
C
D
E
J
K
L
I
H
M
  • Page 1 1

Minka Group 5043-695 User manual

Minka Group
Brand
Minka Group
Model
5043-695
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents