ALGE-Timing CKN User guide

UPTATING SOFTWARE ON CKN COMMAND CONSOLE

CKN command console is driven by Atmel microcontroller (T89C51RD2, AT89C51RD2 or

AT89C51ED2). Basically, programming CKN is programming Atmel microcontroller. Fort this action

you need:

1. CKN command console (picture 1 and 2)

2. Serial DB9 cable for connecting PC and CKN. If other pins than ordinary RS232 on pin 2, 3 and 5

on CKN D-SUB9 connectors are used you shouldn’t use full serial cable. In that case shall be used

3-wire cable that connects following pins: 2<->2, 3<->3 5<->5

3. Software for programming: ATMEL FLIP 3.4.7, can be downloaded from:

http://www.microchip.com/Developmenttools/ProductDetails/FLIP

4. Appropriate new software for CKN console (file with .hex extension in attachment of e-mail)

Picture 1. CKN command console Picture 2. CKN command console – back view

Step 1: Preparing for programming:

-Disconnect CKN from DC source, open the case and connect ‘Programming jumper’ (Jumper PRG,

near the microcontroller, by default it is open)

-Connect serial cable to CKN (picture 2) and to a COM port on PC case.

-Connect DC source to CKN and preparing phase is over.

Picture 3.

Step 2: Programming phase

-Determine microcontroller type. It’s AT89C51ED2

-Open FLIP V 3.4.7 main window. On menu bar go to Device/ Select (picture 4.).

Picture

Picture 4.

Select from the list appropriate microcontroller. In our case it is AT89C51ED2 (picture 5).

-Than again on menu bar go to Settings/Communication/RS232. Select COM port where CKN is

connected and set baud rate to 19200 or more. (Picture 6.).

Picture 5. Picture 6.

-From menu bar select File/Load HEX and pick appropriate hex file. On main Flip window click Run.

-Disconnect CKN from DC source. Disconnect Jumper PRG (back to default position). Disconnect

serial cable and CKN console is ready for use.

Download PDF