Authorised Distributor

Water Filters Australia Pty Limited

Unit 1, 91-93 Old Pittwater Road

BROOKVALE NSW 2100 Australia

PO Box 636

FRESHWATER NSW 2096 Australia

T: +61 2 9905 6211

F: +61 2 9905 6255

E: [email protected]

filter system.

• Remove plastic wrapper and lid from the lter cartridge and t into the lter head – this is achieved by

pushing the lter cartridge into the head and twisting 90° in a clockwise direction.

• Determine the ideal location for the head and cartridge. You must allow a clearance of 300mm under

the lter head (or 65mm below bottom of cartridge) as this will enable the cartridge to be removed and

replaced.

• Once the position is located – screw the lter head to the cabinet wall.

• Connect the John Guest 1/2” female bsp to 1/4” tube connector to the 1/2” male bsp connection on the

mini cistern tap as shown - item 5.

• Cut from the John Guest tubing supplied a length of approx 100mm. Please ensure that the tubing is cut

To ensure a clean and strong connection –

push tubing into tting and when it will go

no further “pull back” against the tting to seal tubing.

• Measure a length of tube from the outlet of the

PLDCV to the inlet of the black head assembly / elbow

connection. Cut tube to length. Insert one end of the

tube into the PLDCV outlet and insert the other

end of tube into the elbow inlet of the filter head.

• Measure the nal length of tube from the outlet

of the lter head to the John Guest connection

purge air and activate system.

3 WAY MIXER TAP WITH WATER FILTRATION SYSTEM INSTALLATION INSTRUCTIONS

1. When installing this system in a new home or kitchen please ensure that the cold water lines under the kitchen sink are ushed to remove all debris within the pipes before

installing the system

2. The Mixer Tap and Water Filter system must be installed in accordance with Australian Standard AS 3500 and local authority By-Laws.

3. The system includes a pressure limiting valve which must be installed with all installations as a legal requirement - if not installed the warranty is null and void.

1. CONNECT TO WATER SUPPLY

If a separate water connection is not provided:

• Locate the Isolation Stop Cock mounted on the wall underneath the sink for the existing cold water line.

• Turn off Isolation Stop Cock and disconnect attached ttings.

• Enclosed within the 3 Way mixer tap carton you will nd installation instructions for the mixer tap.

Follow these carefully and when completed carry out the following tasks.

• Having installed the mixer tap - you will notice that there are three (3) braided hoses connected to the mixer

tap – one hot (marked with red stripes), one cold (marked with blue stripes) and one ltered cold (unmarked).

• Having created the Tee Section as noted above the mains cold braided hose can be connected to the cold

water connection – refer diagram. Obviously, the hot water hose can also be connected to the hot water

connection. Please ensure that all water remains turned off.