2. Set and start a programme for cotton at the highest
temperature without laundry to remove all possible dirt
from the drum and the tub. Put a small quantity of
detergent in the main wash compartment of the
detergent dispenser.
BBeeffoorree FFiirrsstt UUssee
1. Activate the drain system: put 2 litre of water in the main
wash compartment of the detergent dispenser.
START THE APPLIANCE
DDaaiillyy UUssee
1. Open the water tap.
2. Connect the mains plug to the mains socket.
3. Press On/Off button to activate the appliance.
4. Put the laundry in the drum, one item at a time. Make
sure that no laundry stays between the seal and the door.
5. Close the door.
6. Put the detergent and additives in the correct
compartment of the dispenser.
7. Turn the programme knob to set a programme. The
programme indicator comes on.
8. The display shows the default temperature, maximum spin
speed and the empty indicator bar of the available
functions.
To change the default values or to set functions press
the corresponding buttons.
9. If necessary, set the delay start function.
10.Press Start/Pause button to start the washing
programme. Press this button also to interrupt it.
After approximately 15 minutes from the start of the
programme, the display shows the new time value.
11.At the end of the programme the display shows a zero
, the symbol of the last washing phase is on. The
indicator of the Start/Pause button and the door lock
symbol go off.
12.If you set the Rinse Hold function refer to ‘At the end
of the programme’ chapter in the user manual.
Quick Guide S8-Senza WS, EN S-876 KG8.qxd 31/07/2012 15:57 Page 3