GBD
GB
5019 609 02013 Printed in Italy 07/12 - Bauknecht
®
Registered trademark/TM Trademark of Whirlpool group of companies - © Copyright Whirlpool Europe s.r.l. 2012. All rights reserved - http://www.bauknecht.eu
1. Press the On/Off
button.
2. Select the suitable
program for your dishes
by means of the Program
Selection Knob.
3. Start the program by
pressing the Start/Pause
button.
Start/Pause lamp goes out as soon
as the program starts and Wash
lamp lights up.
Lamp on the Start/Pause button
lights up when the On/Off button
is pressed.
OPERATING THE MACHINE
q e w
1. Press the Start/Pause button.
2. Select the desired program by using the Program
Selection Knob after current program stops.
3. Start the new program by pressing the Start/Pause
button again. The new program resumes from the point
that the previous program has stopped.
qe w
You can follow the program flow by means of the program follow-up lamps on the control panel.
As long as washing continues the lights of washing, rinsing and drying are on
respectively. Machine remains silent for about 40-50 minutes when the drying
lamp is on.
When the program ends, end lamp lights up.
Do not open the door before the program ends.
PROGRAM FOLLOW-UP
If you would like to change the program when a washing program is in progress.
CHANGING THE PROGRAM
1. Press the Start/Pause button.
2. Turn the Program Selection Knob to Cancel position
3. Press the Start/Pause button again. Machine discharges
the water in it approximately for 30 seconds after pressing
the button.
4. Program will be cancelled when the End lamp lights up.
qrew
If you would like to cancel a washing program while it is running.
CANCELING A PROGRAM
-
1
