20 / EN
Dryer / User Manual
C
If more than one LED lght up or
flash concurrently, t means there s
malfunctonng or a falure (please
see, Soluton suggestons for
problems).
5.9 Changing the program after
the program has started
You can use this feature to dry your clothes
under higher or lower temperatures after
your dryer has started.
For example;
1. Press and hold the “Start/Pause/Cancel”
button for about 3 seconds to “Cancel”
the programme n order to select “Extra
Dry” programme nstead of “Iron Dry”
programme.
2. Select the “Extra Dry” programme by
rotatng the programme selecton button.
3. Press “Start/Pause/Cancel” button to
start the programme.
C
Press “Start/Pause/Cancel”
button for 3 seconds to cancel the
programme or turn the programme
selecton knob n any drecton to end
the programme whle the machne
s runnng. Water tank and flter
cleanng warnng lghts turn on to
warn the user when the programme
s cancelled by pressng the “Start/
Pause/Cancel” button for 3 seconds.
However, the warnng lghts do not
turn on when the programme s
cancelled by turnng the programme
selecton knob. Only the dryng lght
turns on and the machne remans
n hold untl a new programme s
selected and the “Start/Pause/
Cancel” button s pressed. Chld-
proof lock of the machne should not
be actve n order to perform these
two operatons. If the chld-proof
lock s actve, deactvate t before
performng these operatons.
5.6 Auxiliary function
Buzzer Cancel Models Equiped
Your machine will send out an buzzer
warning when the program comes to an end.
If you do not want to hear this buzzing, you
need to press the “Cancel Audio Warning”
button. The relevant LED will light up when
this button is pressed and an audio warning
will not be given when the program comes to
an end.
Warning indicators
C
Warning indicators may differ
according to the model of your
machine.
Filter cleaning
A warning LED will light up to remind filter
cleaning after the program finishes.
C
If the filter cleaning warning LED
lights up continuously, please
refer to, “Solution suggestions for
problems”.
5.7 Starting the programme
1. Press “Start/Pause/Cancel” button to
start the programme.
2. Lght of the “Start/Pause/Cancel”
button wll turn on to ndcate that the
programme has started.
5.8 Progress of program
Progress of a running program is shown
through the program follow-up indicator.
At the beginning of every program step, the
relevant indicator LED will light up and light
of the completed step will turn off.
“Drying”:
- Dryng level wll be llumnated durng the
whole dryng process untl the dryng
degree reaches “ Ready to Iron “.
“ Ready to Iron “:
- Starts to llumnate when the dryng degree
reaches “ Ready to Iron “ step and remans
llumnated untl the next step.
“ Ready to Wear “:
- Starts to llumnate when the dryng
degree reaches “ Ready to Iron “ step and
remans llumnated untl the next step.
“Final / Anti-creasing”:
- Illumnates when the program comes to an
end and ant-creasng functon s actvated.