Description
The Power Vector Security Cover (PVSC) provides protection against tampering.The sys-
tem settings of a Power Vector amplifier are protected from accidental tampering while
still leaving the power and meter switches accessible. It also provides for access to any
desired input volume control knobs via break-off sections.
Installation
Note: If access to any of the input volume control knobs is desired, be certain to remove the
break-off sections of the PVSC prior to its installation (see below).
1. Line up the PVSC to the front panel of the Power Vector amplifier using the screw
holes as a guide.
2. Attach the PVSC to the amplifier using the three screws provided.
Break-offs
Using a thin, flathead screwdriver, insert the
screwdriver head into the center of the
break-off piece and twist. If necessary, use a
knife or file to take off any sharp edges after
removal.
CAUTION: The break-off piece can fly off
while twisting and become a hazard. Take
reasonable precautions to prevent any flying
pieces from causing injury.
Specifications subject to change without notice.
© 2002 Bogen Communications, Inc.
Part No. 54-2076-01B Printed in USA. 0212
50 Spring Street, Ramsey, NJ 07446, U.S.A.
Tel. 201-934-8500, Fax: 201-934-9832, www.bogen.com
Model PVSC
POWER VECTOR
SECURITY COVER
Description
The Power Vector Security Cover (PVSC) provides protection against tampering.The sys-
tem settings of a Power Vector amplifier are protected from accidental tampering while
still leaving the power and meter switches accessible. It also provides for access to any
desired input volume control knobs via break-off sections.
Installation
Note: If access to any of the input volume control knobs is desired, be certain to remove the
break-off sections of the PVSC prior to its installation (see below).
1. Line up the PVSC to the front panel of the Power Vector amplifier using the screw
holes as a guide.
2. Attach the PVSC to the amplifier using the three screws provided.
Break-offs
Using a thin, flathead screwdriver, insert the
screwdriver head into the center of the
break-off piece and twist. If necessary, use a
knife or file to take off any sharp edges after
removal.
CAUTION: The break-off piece can fly off
while twisting and become a hazard. Take
reasonable precautions to prevent any flying
pieces from causing injury.
Specifications subject to change without notice.
© 2002 Bogen Communications, Inc.
Part No. 54-2076-01B Printed in USA. 0212
50 Spring Street, Ramsey, NJ 07446, U.S.A.
Tel. 201-934-8500, Fax: 201-934-9832, www.bogen.com
Model PVSC
POWER VECTOR
SECURITY COVER
/