Installation
Power Vector amplifiers may be mounted in 19" racks using the RPK87 rack mounting
kit.After having attached the rack ears, place the amplifier into the rack and secure it to
the rack with appropriate hardware (not included).
To Attach the Rack Ears:
1. If any feet have been attached to the bottom of the amplifier, remove them before
proceeding.
2. Remove and save the five cover screws from the chassis of the amplifier.
3. Position the rack ears as shown in the drawing above.
4. Replace and tighten the cover screws to secure the rack attachments.
Model: RPK87
Power Vector Amplifier
Rack Mounting Kit
Specifications subject to change without notice.
© 2001 Bogen Communications, Inc.
Part No. 54-2073-01R1 Printed in Korea. 0112
50 Spring Street, Ramsey, NJ 07446, U.S.A.
Tel. 201-934-8500, Fax: 201-934-9832, www.bogen.com
Model: RPK87
Specifications subject to change without notice.
© 2001 Bogen Communications, Inc.
Part No. 54-2073-01R1 Printed in Korea. 0112
50 Spring Street, Ramsey, New Jersey 07446
Tel. 201-934-8500, Fax: 201-934-9832, www.bogen.com
Power Vector Amplifier
Rack Mounting Kit
Installation
Power Vector amplifiers may be mounted in 19" racks using the RPK87 rack mounting
kit.After having attached the rack ears, place the amplifier into the rack and secure it to
the rack with appropriate hardware (not included).
To Attach the Rack Ears:
1. If any feet have been attached to the bottom of the amplifier, remove them before
proceeding.
2. Remove and save the five cover screws from the chassis of the amplifier.
3. Position the rack ears as shown in the drawing above.
4. Replace and tighten the cover screws to secure the rack attachments.
-
1
Bogen RPK87 User manual
- Type
- User manual
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI