Catalog No. FAP185-1000-01 P
rinted U.S.A
Installation Instructions
INTRODUCTION
These instructions cover the installation of the
Kit canbe
field installed on most existing PTAC units
overheadcurtains.
INSTALLATION
1) Prior to installing the Air Deflector
discharge area of the unit.
In order for the adhesive strip to grip and hold, th
dust, grease, oil, release agents and
2) To get a general idea of location, place the Air
and fits your needs. R
ecord this location by lightly marking both ends with a pencil on the unit.
3) Now it's time to install the A
ir Deflector. Grab hold of the Air Deflector and remove
from adhesive strip.
4) Starting at one
of the pencil marks,
the remaining portion
. Make sure the
5) Using your fingers, firmly
apply pressure to the
to insure the adhesive
is in full contract with the unit surface.
6) U
se an eraser to remove pencil marks.
rinted U.S.A
Form PTAC Air Deflector Kit 4/3/2012
PTAC Air Deflector
Packaged Terminal Air Conditioner
Installation Instructions
These instructions cover the installation of the
PTAC Air Deflector. The PT
AC Air DeflectorAccessory
field installed on most existing PTAC units
. It is designed to guide discharge air away from
1) Prior to installing the Air Deflector
on the PTAC unit, thoroughly clean the
surface
In order for the adhesive strip to grip and hold, th
is area must be free of dirt,
other impurities or foreign material.
2) To get a general idea of location, place the Air
Deflector on the unit
. Select a location that is centered
ecord this location by lightly marking both ends with a pencil on the unit.
ir Deflector. Grab hold of the Air Deflector and remove
of the pencil marks,
carefully lay one end of the Air Deflector
down. T
. Make sure the
Air D
eflector lays flat and meets the other pencil mark.
apply pressure to the
Air Deflector
mounting area along the adhesive strip
is in full contract with the unit surface.
se an eraser to remove pencil marks.
pg. 1
PTAC Air Deflector
Kit
For Use With
Packaged Terminal Air Conditioner
AC Air DeflectorAccessory
. It is designed to guide discharge air away from
surface
s around the air
is area must be free of dirt,
. Select a location that is centered
ecord this location by lightly marking both ends with a pencil on the unit.
ir Deflector. Grab hold of the Air Deflector and remove
the backing tape
down. T
hen slowly lower
eflector lays flat and meets the other pencil mark.
mounting area along the adhesive strip
/
