2. Stratco
  3. Titanium 2 Door Cabinet 900 x 900 x 450mm

Stratco Titanium 2 Door Cabinet 900 x 900 x 450mm Operating instructions

  • Hello! I have reviewed the provided instructions document for the TITANIUM low height metal cabinet, model SS-10214. This document contains step-by-step instructions for assembling the cabinet, a parts list, and safety precautions. The cabinet has a maximum shelf load of 45kg. I'm here to answer any specific questions you have about the assembly process or the features of this cabinet.
  • What is the maximum load each shelf can hold?
    What safety precautions should I take when assembling the cabinet?
    What is recommended to prevent the cabinet from tipping over?
There may be minor variations in the
appearance of some parts from
illustrations due to continued
product improvements.
2 x Side Panels
Top
2 x Middle Shelf
Bottom Shelf
1 x Rear Wall
(install this way up & face
detail towards inside of cabinet)
2 x Keys
Finished size:
1850mm high x
900mm wide x
450mm deep.
C
M
Y
CM
MY
CY
CMY
K
10 x Screws
Finished size:
1850mm high x
900mm wide x
450mm deep.
C
M
Y
CM
MY
CY
CMY
K
Stand the back and right
hand side upright.
Step 2
Insert the cupboard door section
from the inside of the unit.
Step 5
Screw in top and middle screws
to secure Back and RH Side.
Step 3
Fit bottom shelf making sure side slots line up
and that the front of the shelf sits on the lip.
Step 6
Repeat for LH Side.
Step 4
• Get your components ready ahead of the next procedure.
• Use care when using an electric screwdriver not to strip the thread on the screwholes.
TIP
Each shelf can hold a maximum load of 45kg. Please carefully read and follow these
instructions to assemble your cabinet.
ENSURE PROTECTIVE EYEWEAR AND GLOVES ARE WORN WHEN ASSEMBLING THIS UNIT.
Step 1
SS-10214
1
8 x Shelf Supports
CHECK PARTS LIST
TOOLS REQUIRED:
• Phillips Head
Screwdriver
Step 7
Lay unit on it’s back and x
bottom screw in lower shelf.
Finished size:
1850mm high x
900mm wide x
450mm deep.
C
M
Y
CM
MY
CY
CMY
K
2 x Plastic Covers
1 x Front Panel
(Doors & Frame)
LOW HEIGHT METAL CABINET
TITANIUM
JUNE 2023
WARNING: SERIOUS INJURY CAN BE CAUSED BY TOPPLING FURNITURE. To help
prevent tip-over, we recommend you anchor this product to a wall or other suitable surface. Check anchors regularly.
Step 10Step 8
Step 11
Step 9
Step 12 Step 13
Finished size: 900mm high x 900mm wide x 450mm deep
Make sure the top is tted
on all four corners.
Insert shelf supports in the four
corners of the unit at same height.
Please remove doors to place
the top on the unit, front rst.
Rest shelf on supports. Press in plastic covers.
Screw top down with 2 screws
either side as shown.
2
SS-10214
Finished size:
1850mm high x
900mm wide x
450mm deep.
C
M
Y
CM
MY
CY
CMY
K
LOW HEIGHT METAL CABINET
TITANIUM
JUNE 2023
/