Contec PCL5P-3, PCL5P-3 NEW Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Contec PCL5P-3 Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1 PCL5P-3
Unshielded cable with a connector on one end
for M12 (L-Coded) connector
PCL5P-3
Users Guide
CONTEC CO., LTD.
PCL5P-3 is the cable which is used to connect the device with M12 (L-Coded, Male) connector to the
power unit.
Physical Dimensions
Specifications
Item Specification
Connector used M12, 5-pin (4+FE) L-Coded, Female
Recommended torque 0.6Nm
Cable 5-core unshielded cable, Conductor size: 5 x 2.5mm
2
Specification of
wire terminals
Raw
Rated voltage 63V
Rated current
16A/40 °C
Weight 600g
Protection rating IP67 (Connector side, in connected state)
Operating ambient
temperature
-25 °C to +80 °C
PCL5P-3 User’s Guide
Copyright 2020 CONTEC CO., LTD. ALL RIGHTS RESERVED.
CONTEC CO., LTD. September 2020 Edition
3-9-31, Himesato, Nishiyodogawa-ku, Osaka 555-0025, Japan
https://www.contec.com/
NA07212 (LYXY462)
09112020_rev2 [01312020]
No part of this document may be copied or reproduced in any form by any means without prior written
consent of CONTEC CO., LTD.
Notes!
- Do not strike or bend the product. Otherwise, the product may malfunction, overheat, cause a failure or breakage.
- Do not insert or remove the connector while the power is turned on to the PC. Failure to observe this precaution
may cause malfunction, overheating.
- Insert or remove the cable straightly. Otherwise, the part of connector may distort, cause a failure or breakage.
- The specifications of this product are subject to change without notice for quality improvement.
Even when using the product continuously, be sure to read the manual and understand the contents.
- Regardless of the foregoing statement, CONTEC assumes no responsibility for any errors that may appear in this
document or for any results of using the product.
- Tighten the cable screw with the specified torque.
- To meet the IP67 rating, the cable must be connected to an IP67 compatible connector.
-
All relevant issues have been considered in the preparation of this document. Should you notice an omission or
any questionable item in this document, please feel free to notify CONTEC CO., LTD.
Connection Diagram
/