+
-
ADJUSTMENTS
Compression damping
Low speed: Turn the slotted centre
screw. High speed: Turn the hexagon
screw. Turn clockwise (+) to increase
damping, turn counter clockwise (-) to
decrease.
Rebound damping
Turn the screw above the end eye/
bracket. Turn clockwise (+) to increase
damping, turn counter clockwise (-) to
decrease.
NOTE!
When delivered the Öhlins shock absorber
is dialed to recommended settings for the
specic brand and make of the vehicle. If you
have changed the setting, reset according to
the Set-up data.
To reset: The adjuster has a right hand thread.
Turn the adjuster clockwise to fully closed
(pos. zero [0]). Turn counter clockwise to
open and count the clicks until you reach the
recommended number in the Set-up data.
CAUTION!
Do not use force, delicate sealing surfaces can
be damaged. Handtighten only.
2
Before installing this product, read the Öhlins Owner’s Manual!
© Öhlins Racing AB. All rights reserved. Any reprinting or unauthorized use without the written permission of
Öhlins Racing AB is prohibited. Printed in Sweden.
Öhlins Racing AB, Box 722, S-194 27 Upplands Väsby, Sweden.
Phone +46 8 590 025 00 Fax +46 8 590 025 80
www.ohlins.com
-
-
+
+
Shock absorber SK1204 1
Öhlins Sticker 00197-01 2
Memo Notes Sticker 01180-01 1
Owner’s Manual 07230-02 1
Mounting Instructions SK1204 Issued 2011-12-15 Öhlins Racing AB
Before installing this product, check
the contents of the kit listed below. If
anything is missing, please contact your
nearest Öhlins dealer.
Kit Contents
Art.No Pcs.
During storage and transportation,
especially at high ambient temperature,
the oil and grease used for assembling
may run out inside the packing and
damage the expanded polystyrene
packing material. This is not unusual
and is in no way detrimental to the
product.
2
Mounting Instruction
SHOCK ABSORBER SK1204 Rear
for Ski-Doo 600 RS
with set-up data
1
1
1
MOUNTING INSTRUCTIONS
WARNING!
Make sure the vehicle is securely positioned so
that it will not tip!
1
Raise the rear end of the snowmobile.
2
Remove the original rear shock absorber.
3
Install the Öhlins shock absorber with the
reservoir facing downwards. Use the original
screw and nut, use standard position for limiters.
NOTE!
Make sure that all bolts are tightened to the
correct torque and that nothing fouls or restricts
movement of the shock absorber when the
suspension is fully compressed or extended.
4
When riding the snowmobile wearing all your
riding gear, you must increase or decrease the
rear spring preload until the lower part of the rear
arm is approx 10 mm from the rubber stop. The
spring preload adjustment is based on your total
weight (inclusive luggage or/and a passenger).
5
Read more about the shock absorber in your
Öhlins Owner’s Manual.
SET-UP DATA
Set-up data
Compression damping High speed 1 turns
Compression damping Low speed 12 clicks
Rebound damping 14 clicks
Shock absorber data
Length 436,5 mm
Stroke 150,5 mm
Approx
10 mm
Rear
Reservoir
Inner idler
wheel
3
4
Rear arm
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ohlins SK832 Mounting Instruction
-
-
-
-
-
-
-
-
-