2.4G receiver Manual
Products Profile
1.Compatible with USB1.1/2.0specifications ,supporting USB-IF and WHQL testing
2.16 channel frequency hopping and Strong anti-jamming capability
3.Support 8*18 matrix ,standard 104/107 Keys,support 88 Keysmall keyboard
function, Size keyboard sharing receiver
4.Support 18 PCS multimedia keys ,and special function keys,support FN+F1-F12
function.
5.Support battery low alarm,support CAPS LOCK ,NUM LOCK indicator light,
LED status and hostsynchronization
6.Built - in maintenance mode ,tofacilitatethe testing and maintenance of defective
products
7.Support computer hibernation wake up and wakefromhibernation
8.Wireless remote control distance greaterthan 10 meters
9. Intelligent multi-level power-saving design
10.Support keyboardand mouse combo set
Installation Instructions
1. Open you computer
2. The receiver is inserted into the computer to an idle USB interface,
3. the computer will automatically identify the USB device and automatically
complete the installation, after the completion of the installation can be used
4. Open the keyboard's battery cover, right into the battery, keyboard and receiver
connections use
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequence energy and,if not installed and used in
accordance with the instructions,may cause harmful interference to radio communications.However,there is no
guarantee that interference will not occur in a particular installation.if this equipmemt does cause harmful
interference to radio or television reception,which can be determined by turning the equipment off and on,the
user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an autlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
/
