Esatto EBF95S Quick start guide

  • Hello! I've reviewed the Quick Start Guide for the Esatto Bar Fridge EBF95W. This guide provides information on initial setup, temperature controls, and features such as the drain tray, wire shelves, and adjustable feet. I'm ready to help you with any questions you might have about your new fridge.
  • How long should I wait before connecting the fridge to the power supply after unpacking?
    What is the recommended thermostat setting when first using the fridge?
    How long should I wait before loading the fridge with food or drinks?
93L Br Fridge
Model: EBF95W
Here is  little Quick Strt Guide so you cn
strt chilling with your new Estto Br Fridge
—exctly wht you need!
93L Br Fridge
Model: EBF95W
Redy? Lets get strted.
QSG V1.1
@esatto.house @esatto.house
When starting up for the rst time, keep
the refrigerator upright for 2 hours before
connecting it to power supply.
Once the power is connected to the
appliance, set the thermostat knob to “Med”.
Give your refrigerator time to cool down
completely before adding food or drinks. It is
the best to wait 24 hours.
Note: Please refer to your User Manual Pages 9–10
for detailed installation instructions.
Installation Tips
Size (mm) / 472W x 450D x 850H
Energy Rating / 3.5 Stars
Warranty / 2 Years
Product Details Get in touch
Your Bar Fridge
We’re on socials!
Need help? Contact our friendly support team via
the contact details below.
Phone / 1300 11 4357
Email / support@residentiagroup.com.au
How was your Esatto experience?
Share your story at esatto.house/review
The thermostat controls are located on the upper
wall of your Bar Fridge interior. The temperature
settings are as follows;
O : This turns the unit o
Min: The warmest temperature setting
Med: Normal operation (adequate for
most situations)
Max: The coolest temperature setting
Note: Please refer to your User Manual Page 11 for
detailed operation instructions.
The Thermostat Controls
Small Door
Drain Tray
Steel Wire Shelves
Adjustable Foot
Door Storage
Thermostat Controls
/