Kichler Lighting 52149WH User manual

  • Hello! I am an AI chatbot trained to assist you with the Kichler Lighting 52149WH User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
IS-52149-US
Were here to help 866-558-5706
Hrs: M-F 9am to 5pm EST
1) Slip rubber washer[O] onto threads of studded nial[L]
and screw studded nial into shade[N], making sure
rubber washer is between studded nial and outside
surface of shade. Repeat for two (2) remaining holes in
shade.
2) Pass xture wires from shade[N] through desired
number of stems[A] and short threaded tubes[B]. Screw
stems together using short threaded tubes.
NOTE: Thread locking compound must be applied to
all stem threads as noted with symbol (4) to prevent
accidental rotaon of xture during cleaning, relamping,
etc.
Fixture Diagram
Parts List
[A] Stems
[B] Short
Threaded
Tubes
[C] Swivel
[D] Canopy
[E] Lockwasher
[F] Hexnut
[G] Mounting
Strap
[H] Mounting
Screws
[I] Outlet Box
[J] Knobs
[K] Lockwashers
[L] Studded
Finial
[M] Strap
Mounting
Screws
[N] Shade
[O] Rubber
Washer
Cauons
CAUTION – RISK OF SHOCK –
Disconnect Power at the main circuit breaker panel or main
fusebox before starng and during the installaon.
WARNING:
This xture is intended for installaon in accordance
with the Naonal Electrical Code (NEC) and all local code
specicaons. If you are not familiar with code requirements,
installaon by a cered electrician is recommended.
CLEANING:
• Always be certain that electric current is turned o before
cleaning.
• Only a so damp cloth should be used. Harsh cleaning
products may damage the nish.
Installaon Instrucons (connued)
Installaon Instrucons
3) Screw rst stem into coupling aached to top of shade.
4) Pass xture wires from last stem through swivel[C].
Swivel should be installed with the longer end hanging
down towards the mounng stems.
5) Screw longer end of swivel into end of last stem.
Note direcon of swivel in accordance with ceiling. If
swivel is not yet installed, follow steps 6, 7 & 8. If swivel is
already installed, go to step 9.
6) Pass xture wire through hole in canopy[D]. Pass
threaded pipe on end of swivel up through hole in
canopy.
7) Pass xture wire through lockwasher[E] . Thread
lockwasher onto end of threaded pipe protruding from
inside canopy.
8) Pass xture wire through hexnut[F]. Thread hexnut onto
end of threaded pipe.
NOTE: Fixture wire should not be cut shorter than 20
inches from above the canopy.
9) Find the appropriate threaded holes on mounng
strap[G]. Assemble mounng screws[H] into threaded
holes.
10) Aach mounng strap to outlet box[I] using the strap
mounng screws[M]. Mounng strap can be adjusted to
suit posion of xture.
11) Grounding instrucons: (See Illus. a or b).
a) On xtures where mounng strap is provided with a
hole and two raised dimples, wrap ground wire from
outlet box around green ground screw, and thread
into hole.
b) On xtures where a cupped washer is provided,
aach ground wire from outlet box under cupped
washer and green ground screw, then thread into
mounng strap.
If xture is provided with ground wire, connect xture
ground wire to outlet box ground wire with wire
connector aer following the above steps. Never connect
ground wire to black or white power supply wires.
12) Make wire connecon. Reference chart below for correct
connecons and wire accordingly.
Connect Black or Red
Supply Wire to:
Connect White Supply
Wire to:
Black White
*Parallel cord (round &
smooth)
*Parallel cord (square &
ridged)
Clear, Brown, Gold or
Black without Tracer
Clear, Brown, Gold or Black
with Tracer
Insulated wire (other
than green) with copper
conductor
Insulated wire (other
than green) with silver
conductor
*Note: When parallel wire (SPT
1 & SPT 2) are used. The neutral
wire is square shaped or ridged
and the other wire will be round
in shape or smooth (See illus.)
Neutral Wire
13) Push xture to ceiling, carefully passing mounng screws
through holes in canopy.
NOTE: Be certain wires do not get pinched between
mounng strap and canopy, or canopy and ceiling.
14) Use knobs[J] and lockwashers[K] to secure canopy.
Tighten to secure.
15) Insert recommended bulb (Not supplied).
GREEN GROUND
SCREW
CUPPED
WASHER
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
WIRE CONNECTOR
OUTLET BOX
GROUND
GREEN GROUND
SCREW
FIXTURE
GROUND
a
b
B
A
A
N
O
L
E
D
J
K
F
I
G
H
M
C
/