Feiss F3136/8DWK/SGM Installation guide

Feiss
Brand
Feiss
Model
F3136/8DWK/SGM
Type
Installation guide

This manual is also suitable for

Installation Instructions for
Chandelier
1A
Temporarily install the mounting plate to the junction box.
Mark the anchor locations through the holes on the mounting plate, then remove the mounting plate.
Install the anchors to the marked points.
Secure the mounting plate to the junction box.
Screw the anchor screws into the anchors.
Determine the height of the fixture with the provided stems and assemble them by screwing them together.
Feed the cord through the stem assembly and screw the stem assemblies to the fixture.
Feed the cord through the swivels and screw them to the stem assemblies.
Secure the swivels to the canopy and canopy plate with the provided nuts and washers.
Pull the power line wires out of the junction box. Trim the cord leaving enough to make electrical connections.
Connect the fixture to a suitable ground in accordance with local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the electrical box, place the canopy onto the mounting plate, and secure it in place by screwing in
the fixture screws.
Install the shade by placing it into the shade base. Repeat for remaining shades.
Screw the lamps into the sockets. Refer to the label on the socket for Max Wattage Information.
1
2
3
4
5
6
7
8
9
10
11
1
CAUTION RISK OF FIRE-
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
12
13
14
15
16
Angelo Chandelier
1.0
F3136-8
F3136/8
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
HEX NUT
WASHERS
MOUNTING PLATE
CANOPY PLATE
ANCHOR
ANCHOR SCREW
SWIVEL
STEM
CANOPY
FIXTURE SCREW
LAMP
3
5
6
7
8
9
14
15
16
SHADE
SOCKET
SHADE BASE
Page is loading ...
Page is loading ...
SAVETHESE INSTRUCTIONS!
4
7400 Linder Ave, Skokie, 60077IL
800.969.3347
www.Feiss.com
© 2017 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Feiss F3136/8DWK/SGM Installation guide

Feiss
Brand
Feiss
Model
F3136/8DWK/SGM
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents