1
© 2018 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
Move System Fixed Swing Arm Assembly Installation (002-10062-00)
003-10083-00 Rev.AA1 3/12/18
Caution
Always disconnect power to chair before removing
covers or performing any service procedures.
Style A
Note
626 Shown.
4” x 4”
Block
Note
For parts list, refer to the 626 Service and Parts manual.
Step 2: Install Fixed Swing Arm Assembly
A) Install Rear Bolt partially into Fixed Swing Arm Assembly
and insert up into bottom of chair frame.
B) Drop Rear Bolt into slot and pull toward head end of chair.
C) Install Front Bolt. Then tighten both Front and Rear Bolts.
D) Raise chair base and remove 4” x 4” block and lower chair.
MA10709i
Step 1: Remove Fixed Swing Arm Assembly
A) Raise chair base and block up with 4” x 4” block.
B) Remove Front Bolt and loosen Rear Bolt.
C) Slide Fixed Swing Arm Assembly toward the foot
end of chair, Lift Rear Bolt out of slot.
D) Rotate Fixed Swing Arm Assembly down and
remove from bottom of chair base.
Rear Bolt
Front Bolt
Fixed Swing
Arm Assembly
Fixed Swing
Arm Assembly
Internal View
Bottom View
midmark.com
/
