ARMIN STROM – SKELETON PURE - CALIBRE ARM09-S
(POWER RESERVE INDICATOR)
INSTRUCTIONS FOR USE
Thank you for buying an Armin Strom watch.
Developed and manufactured in-house, the ARM09-S calibre of your watch is a self-
winding mechanical movement with a power-reserve indicator. Its two barrels ensure
an exceptional eight-day power-reserve.
To guarantee the perfect working of your watch for many years to come, please pay
careful attention to the recommendations for use set out in these instructions.
Hours Minutes
Seconds Position 1: winding
Power-reserve indicator Position 2: setting the time
WINDING
Your manual mechanical watch must be wound regularly for it to work properly. To
do so, turn the crown clockwise in position 1 until it locks, which indicates that the
movement is completely wound. It is important to never put strain on the crown,
since this could damage the mechanism.
When fully wound, your watch has a minimum power-reserve of seven days. Your
watch must be wound regularly for it to work properly.
When the power-reserve indicator (in red below) approaches its lowest point (down),
it is time to wind your watch. Wind your watch completely until the indicator reaches
its maximal position (up).
Power-reserve (down)
Wind your watch.
Power-reserve (up)
Your watch is wound.
SETTING THE TIME
Pull the crown out to position 2. Adjust the hours and minutes by turning the crown
forwards or backwards.
Important: Always push the crown back to position 1 once the settings have been
made.
/
