72
SAFETY INSTRUCTIONS _______________________
Carefully read these instructions and keep them so that you
can consult them when necessary.
Carefully examine the power cord before using the unit. If it is
damaged, do not use the unit. The cord should only be replaced
by , its service department or a qualified person
approved by in order to avoid any danger for the
user. The cord used is a HO3VVH2-F 2 x 0.75 mm².
Always unwind the cord completely.
Place your unit on a flat surface in a sufficiently ventilated area
Do not put your unit on a fragile surface, wood, marquetry, fabric
tablecloths.
Warning: do not use your unit for more than 40 hours straight.
After 40 hours, disconnect the unit and let it cool for at least two
hours before using it again.
Do not use near aerosols under pressure or fuels.
Do not cover the unit with a cloth during use (risk of fire). Never
cover the air intake and exhaust openings.
Do not use the unit outside.
Never put your unit on a hot surface or near a flame.
Connect the power cord plug to a 10/16 A 230V outlet.
We recommend connecting the unit to an installation that has a
residual current system with a breaking current not exceeding
30mA.
If you need to use an extension cord, you must use a model with
wires of section greater than or equal to 0.75 mm².
Make sure that children do not play with the unit.
People (including children) who are not capable of using the unit
safely, either due to their physical, sensorial or mental capacities,
or because of their lack of experience or knowledge, must not
be allowed to use the unit without surveillance or instructions
from a responsible person.
Before any handling, unplug the unit.
Never put your unit into water.
For your safety, we recommend that you never use or leave your
unit in a place exposed to foul weather and moisture.
Do not use the unit with wet hands.
Never pour liquids into the unit.
Never leave your unit connected without regular surveillance.
Do not move the unit when it is in operation.
Do not recess the unit.
These units are not intended to be started by exterior timers or
remote control systems.
If your unit is damaged, do not use it and contact the
Service Department.
For your safety, use only accessories and spare parts
adapted to your unit.
Do not use the unit for purposes other than those for which it
was designed.
CHARACTERISTICS ___________________________
Base of the unit made of thermoplastic
Vented cover
5 stackable drying plates (diameter 32 cm, or about 0.4 m² of
total drying area)
Polystyrene plates and cover
Temperature selector
230 Volts - 50 Hz - 250 Watts
This unit is in compliance with directives 2006/95/EC, 2004/108/EC,
DEEE 2002/96/EC, RoHs 2002/95/EC and EC regulation 1935/2004
regarding contact with food.