CMYBabee TN760 User guide

Brand: CMYBabee

Model: TN760

Type: User guide

Thanks for purchasing our compatible Brother TN760 black

high yield toner cartridge.

Brother HL Printer Series

·Brother HL-L2350DW

·Brother HL-L2370DW

·Brother HL-L2370DW XL

·Brother HL-L2390DW

·Brother HL-L2395DW

Brother DCP Printer Series

·Brother DCP-L2550DW

Brother MFC Printer Series

·Brother MFC-L2710DW

·Brother MCF-L2730DW

·Brother MFC-L2750DW

·Brother MFC-L2750DW XL

TN760

ISO9001 / ISO14001

Black - up to 3,000 pages at 5% coverage (Letter/A4)

→Clean the corona wire.

This issue may have occurred because the corona wire has

become dirty. Here is the details of how to clean the corona

wire.

Remove the toner cartridge and drum unit assembly from the

machine.

After replacing a toner cartridge, DO NOT turn off the machine or open the

Front cover until the machine's display returns to Ready Mode.

Grasp both side of the toner

cartridge, and then distribute the

toner by gently rocking the toner

cartridge back for forth.

Put the new toner cartridge ﬁrmly

into the drum unit until you hear it

lock into place. (Drum unit is not

included in your order.)

Install the toner cartridge and

drum unit assembly back into

the machine.

Be sure to return the tab to the Home position ( ). The arrow on the tab

must be aligned with the arrow on the drum unit. If it is not, printed pages

may have a vertical stripe.

Clean the corona wire inside the

drum unit by gently sliding the

green tab from left to right and

right to left several times.

The Drum Counter Reset Instruction



Pay attention to the following points

1.Put the new drum and toner cartridge assembly into the

machine. DO NOT close the front cover to reset the drum

counter.

2.For HL-XXX Printer

Press and hold down the “GO” for 4 seconds until all the LEDs

light up. Once all four LEDs are lit, release “GO”. Close the

front cover.

3.For HL-XXX Printer

Press “Clear” to conﬁrm you are installing a new drum, press

when the LCD shows “Accepted” and close the front cover.

4.For MFC-XXX and FAX-XXX Printer

Press “Clear” to conﬁrm you are installing a new drum, press ”1”

when the LCD shows “Accepted” and close the front cover.

Troubleshooting

If the machine's display or LED continues to show the "Toner

Low", "Replace Toner" or "Toner Ended" error indication after

installing a new toner cartridge, follow the steps below to

resolve the issue.

→ Verify that you replace the correct consumable.

→ Verify you are using a NEW toner cartridge.

When replacing the toner cartridge, you MUST install a new

unused toner cartridge in order to reset the toner status.

Swapping toner cartridges from one machine to another or

installing a partially used toner cartridge may cause this issue.

Brother machine control their image quality for the most suitable

print quality by monitoring toner consumption. If you install a

partially used toner cartridge, your Brother machine is unable

to recognize toner consumption correctly which will cause this

issue. Therefore, when you replace the toner cartridge, use a

new toner cartridge, not a partially used toner cartridge from

another machine.

→Verify the toner cartridge is installed correctly.

If you install a new Brother toner cartridge but the "Toner Low",

"Replace Toner" or "Toner Ended" error indication remains,

the toner cartridge may not be installed correctly.

Reinstall the toner cartridge, referring to the instructions on

how to replace the toner cartridge.

Conﬁrm that you have installed both a toner cartridge and a drum unit in

the machine.

Clean the corona wire inside the drum unit by gently sliding

the green tab from left to right and right to left several times.

If printer pop-up message "Non-Genuine", "Non-Original"

please ignore and click "OK" or "Next" to continue.

If your printer can't recognize toner cartridge, turn printer

off and on, put toner cartridge back and try again.

Installing different brand cartridges may cause blending

color by air pressure difference in cartridges.

Remove the toner cartridge

and drum unit assembly from

the machine.

Push down the green lock lever

and take the toner cartridge out

of the drum unit.

Step

4 5

Remove the orange protective

cover.

Find the chip at the backside of the original toner cartridge, pry out the chip

with the plastic crowbar carefully and insert the chip into the new toner.

DO NOT scratch the chip. The plastic crowbar is included inside the

package. Please skip to Step-4 if your product was come with chip.

r TN

Comp

atib

·1-Year warranty (from purchase date).

·Free Replacement or Money Back in 3 months.

·24/7 customer support.

Be sure to return the tab to the Home position ( ). The arrow

on the tab must be aligned with the arrow on the drum unit. If it is not,

printed pages may have a vertical stripe.

5 64

2 31



‚

„

If you have any problem, please feel free to contact us .

Logging in your your Amazon Account > Click Your Account >

Your Orders > Find your order and Click Contact Seller All .

emails will be responded within 24 hours.

TONER CARTRIDGE

Warranty & Support

Compatible Printer

Page Yield

Speciﬁcation

Installation Guide

plastic

crowbar

Recycling

2. Ruturn the used cartridge to local recycling company.

We appreciate your support and participation in this earth environment

green program. Your small effort means a big step towards a clean and

healthy environment for all of us.

How to return and recycling used cartridge?

1. Put the used cartridge inside the plastic bag to avoid the

unused toner coming off.

CMYBabee TN760 User guide

Brand: CMYBabee

Model: TN760

Type: User guide

Download PDF

report

CMYBabee TN760 User guide

CMYBabee TN760 User guide

Other documents