2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Legrand
  7. Optex Mounting Plate - 364514-01

Legrand Optex Mounting Plate - 364514-01 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Legrand Optex Mounting Plate - 364514-01 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1. Introduction
The OnQ Optex Mounting Plate is to be used with
Optex Vision Security Systems. The mounting plate
can be installed in any OnQ Service Center
Enclosure.
2. Description
The Mounting Plate is a full-width plate that
measures 7.9” H x 6.42” W.
3. Installation
Mounting in OnQ Enclosure (refer to Figure 2):
a) Align tabs on the mounting plate with slots
in enclosure.
b) Insert tabs by angling mounting plate away from the back of the enclosure.
c) Rotate the mounting plate and insert fasteners on mounting plate into corresponding holes on rail of
enclosure. (Plunger must be in a pulled position for fastener to engage hole).
d) Push plunger in to lock mounting plate in place. Pull on plate to ensure it is locked properly in place.
OnQ Technologies, Inc.
P.O. Box 60907
Harrisburg, PA 17106-0907
800-321-2343
www.onqtech.com
Installation/Instruction Sheet
Optex Mounting Plate
IS-0169 Rev. O
IS-0169 Rev. O Page 1 of 1
Ref. P/N 100225-69
Optex Mounting Plate
Figure 2
Example view - placement in OnQ Enclosure
/