Whirlpool AWM 6105/P Program Chart

Brand: Whirlpool

Model: AWM 6105/P

Category: Washing machines

Type: Program Chart

GB AWM 6105/P

5019 301 10247

Programme

Care

Labels

Type of wash / Notes

Max.

Load

Detergents and Additives Special options Max.

Spin

Speed

rpm

Programme

Selector

Softener Main

Wash

Pre-

wash

Start

Delay

Opóź-

nienie

startu

Eco

Easy

Ironing

Bez

zagnie-

ceń

Prewash

Pranie

wstêpne

Intensive

Rinse

Intensivne

p³ukanie

Rinse

Hold

Zatrzy-

manie

p³ukania

Spin Speed

Reduction

Zmniejszenie

szybkości

wirowania

Cotton

Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton

and linen.

With heavily soiled laundry the additional “Prewash” option can be selected as well.

5,0

Yes

i i i i i i i i

1000

Bawełniane

95°,60°,40°

Synthetics

Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon,

Nylon) or blends with cotton.

2,5

Yes

i i i i i i i i

800

Syntetyczne

60°,40°

Daily Slightly to normally soiled textiles made of cotton and/or synthetics. 3,0

Yes –

–

i i i

1000

Codzienne

60 min.

40°

Short Shortly worm outer clothing made of cotton, polyester, polyamide and blends with cotton. 3,0

Yes –

– – –

i i i

1000

Program

szybki

30°

Delicate Curtains and delicate clothing, dresses, skirts, shirts and blouses. 1,5

Yes

i i

– –

–

i i

800

Delikatne

40°,30°

Wool

Textiles made of silk, linen, wool and viscose marked as “handwashable”.

This cycle is particularly suitable to treat delicate lingerie (use of a laundry net strongly recommended).

If you select “Rinse Hold” do not leave items to soak for too long. A very gentle spin is used in this programme.

1,0

Yes –

– – – –

i i

800

Wełniane

30°,20°

Handwash/

Lingerie

Textiles made of silk, linen, wool and viscose marked as “handwashable”.

If you select “Rinse Hold” do not leave items to soak for too long. No spinning.

1,0

Yes –

– – – –

– 400

Pranie rêczne

Bielizna

30°

Rinse + spin – Same as the last rinse and final spin in the “Cotton” programme. 5,0

– –

–

i i i

1000

Płukanie i

wirowanie

Spin – In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. 5,0 – – –

–

– – –

1000

Wirowanie

Gentle Spin – In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme. 1,5 – – –

– – – – –

800

Delikatne

wirowanie

Drain – Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”. – – – –

– – – – – –

Wypompo-

wanie

i : option / Yes : dosing required

For improved garment care spin speed is restricted to

800 rpm in this programme.

For improved garment care spin speed is restricted to

400 rpm in this programme.

A. Programme Sequence Indicator

B. “Start/Pause” Button

C. “Door Open” Indication

D. “Spin Speed Reduction” Button

E. “Start/Delay” Button

Whirlpool is a registered trademark of Whirlpool USA.

Selecting any option the indication lights up.

When the combination of programme, additional options

and temperature is not possible, the indication lights

switch off automatically. Unsuitable combinations of

options are deselected automatically.

5019 301 10247

Programme

Temperature

Selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes)*

Cotton 95 5,0 49** 1,90 2:00

Cotton 60 5,0 44 0,85 2:20

Cotton 40 4,5 44 0,60 2:05

Synthetics 60 2,5 55 0,80 1:30

Synthetics 40 2,5 55 0,60 1:20

Daily 40 3,0 45 0,50 1:00

Short 30 3,0 37 0,40 0:30

Delicates 40 1,5 60 0,60 0:45

Wool 30 1,0 60 0,30 0:40

Handwash/Lingerie 30 1,0 45 0,30 0:40

Add the detergents as described in the programme table

or in the chapter “Detergents and Additives” in the

booklet.

1. Turn the programme selector knob to the desired

programme and temperature.

2. The remaining time display shows the duration of

the chosen programme (in hours and minutes)

and after taking some seconds for calculating, the

pilot lamp of the “Start/Pause” button is flashing.

3. The programme sequence and the predefined spin

speed indication corresponding to the selected

programme lights up.

CONSUMPTION DATA

Prewash cycle might increase programme duration. Consumption values were measured in normalized conditions in compliance with

standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply

pressure and temperature, the load and the type of wash.

* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household

conditions applicable at that time.

** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water

out.

ADD DETERGENTS, CLOSE THE DOOR AND

SELECT THE PROGRAMME

SELECT ANY DESIRED OPTION

“Eco” button

• The duration of the wash is extended and the

temperature reduced to save up to 40% of energy

but maintaining good washing results.

“Easy Ironing” button

• Can be used together with Cotton, Synthetics and

Daily programmes to make ironong easier.

• Increases the water quantity and the clothes are

spun very soft.

“Prewash” button

• Only for heavily soiled loads (for example sand,

granular dirt) sensible. The cycle time increases

approximately 15 min.

“Intensive Rinse” button

• The amount of water is increased to ensure a more

intensive rinse.

• This option is particulary suitable for areas with very

soft water, washing baby linen and people with

detergents allergies.

“Rinse Hold” button

• The laundry remains in the last rinse water without

progressing to the final spin cycle to avoid creasing

and prevent colours from changing.

• This option is particularly recommended for the

programme “Synthetics”, “Delicates” and “Daily”.

Whirlpool is a registered trademark of Whirlpool USA.

• This function is particularly useful if you want to

postpone spinning to a later time, or if you want to

drain only.

Note: The programme stops to “Rinse Hold” at the time

the “Rinse Hold” light in the programme flow indication

is on.

Terminate the “Rinse Hold” option:

• Press the “Rinse Hold” button again; the

programme will terminate automatically with the

final spin cycle for the present wash

programme.

• If you do not wish to spin the clothes, turn the

programme selector knob counterclockwise to the

“Drain” programme and press the “Start/Pause”

button again when flashing.

“Spin Speed Reduction” button

• Every programme has an automatic predefined

maximum spin speed.

• Press the button to set another spin speed.

• If the spin speed “0” is selected, the final spinning

is cancelled but intermediate spin peaks remain

during rinse. The water is drained out only.

Selecting any option the indication lights up.

When the combination of programme, additional

options and temperature is not possible,

the indication lights switch off automatically.

Unsuitable combinations of options are deselected

automatically.

CHANGE THE PROGRAMME, TEMPERATURE,

OPTIONS AFTER PROGRAMME START

1. Press the “Start/Pause” button to pause the

progamme. The light flashes.

2. Select the new programme (with temperature), any

options and another spin speed if you want.

3. Press the “Start/Pause” button again. The new

programme continues at the same position where

the previous programme was interrupted. Do not

add detergent for this programme.

CANCEL A PROGRAMME BEFORE THE END

1. Press the “Start/Pause” button to pause the

progamme. The light flashes.

2. Set the programme selector to “Drain”.

The spin indicators show “0” and the remaining

time shows “0:02”.

3. Press the “Start/Pause” button to start the drain

progamme.

PROGRAMME END

• The remaining time is on “0:00” and all the lights of

the programme sequence indication are off.

1. Turn the programme selector to the “ “ position.

2. Turn the water supply tap off.

3. Open the door and unload the machine.

4. Close the tap and and leave the door ajar to allow

the drum to dry out.

START DELAY

The “Start Delay” allows to run the machine at the

consumer's convenience, for example at night when

electricity is cheaper.

• Press the “Start Delay” button to select the delay

time by 1 to 23 hours.

• Press the “Start/Pause” button.

• The time delay indication disappears when the

programme starts and it's replaced by the remaining

time.

• The number of hours preselected can later be

reduced pressing again the “Start Delay” button.

To cancel the “Start Delay”

• Turn the programme selector to the “ “.

• Reselect the desired programme and options and

press the “Start/Pause” button.

PROGRAMME START

Open the tap and press the “Start/Pause” button. The

“Start/Pause” button lights up.

The indicator lamps show the sequence reached in the

programme. After starting the programme, the sequence

indication runs from left to right through Wash, Rinse,

Spin.

When the sequence of the programme is finished the

corresponding lamp goes out.

DOOR LOCK

The door can be opened when the “Door Open”

indication is on.

Whirlpool AWM 6105/P Program Chart

Brand: Whirlpool

Model: AWM 6105/P

Category: Washing machines

Type: Program Chart

Download PDF

report

Whirlpool AWM 6105/P Program Chart

Whirlpool AWM 6105/P Program Chart

Related papers

Other documents