2. Broan
  3. 4037768
4037768

Broan 4037768 User manual

  • I've reviewed the instructions for the Broan Dehumidifier 4037768 rear panel kit. This document details the steps for installing the rear panel, including inserting grommets and connecting the drain hose. I'm here to help answer your questions about the installation process.
  • What screws should I use for wood studs?
    What screws should I use for metal studs?
    What is included in the kit?
Step 1. Insert Grommets
In-Wall Dehumidifier
Rear Panel Kit
Part No. 4037768
Parts Included:
1. Rear Panel
2. Screw A (x5) - Pan Head, course pointed screw for wood
3. Screw B (x5) - Truss Head, self-drilling screw for metal studs
4. Plastic Grommet / Drain Hose Bushing
Tools Required:
• Drill/Screwdriver
TOLL-FREE 1-800-558-1711 • www.Broan-Nutone.com
TS-1221 10/21 Rev A
2
3
4
Insert plastic grommet included with
the in-wall dehumidier to the back of
the unit after punching out the knock
out hole for the drain hose.
Insert plastic grommet included with
this kit to the back of the rear panel.
(x5)
(x5)
CONTINUED
4038985 4037854
DRAIN HOSE
BUSHING
REMOVE DRAIN HOSE
KNOCK OUT
1.6"
32.2"
16.6"
1
TOLL-FREE 1-800-558-1711 • www.Broan-Nutone.com
Route the drain hose through the
rear panel and the dehumidier to
connect to the drain pan.
Be sure the drain hose knock out
and the electrical wiring knock out
on the rear panel line up with the
dehumidier.
Step 2. Install Drain Hose
Step 3. Install Rear Panel
Check that there is no strain on
the drain hose and power cord.
Locate the four holes on the rear
panel and fasten to the wall with
the appropriate screws based on
the stud type. Screw A can be
used for wood studs and Screw B
can be used for metal studs.
4037854
DRAIN HOSE
DRAIN HOSE
BUSHING DRAIN HOSE
SIDE VIEW
SCREW B
/