Ralph Lauren RL 3320 Installation guide

1. Carefully remove all parts from the box. Place on a clean, soft surface.

2. Put all the parts on the table.

3. Insert the male plug on driver (B) to female plug (A) on base, then

plug on the stem.

4. Press the button switch (K) and turn on the table lamp, press it in a

short time and it will be on or off.

5. After the table lamp is turn on, press the switch (K) in a longer time,

it will be bright & dim.

6. The horizontal stem can be rotated by 20° at the joint (D), as shown

on the Fig.1.

7. The vertical stem can be rotated from the vertical status to left by 20°

at the joint (C).

8. Installation is complete.

9. Warm tips: Please lock the knob (F) if the stem(E) is loose when

swing.

Care Instructions: Clean only with a soft dry cloth or feather duster. Do

not use abrasive or chemical agents.

Daley Adjustable Desk Lamp

Item # RL 3320

ASSEMBLY INSTRUCTIONS

This light fixture should be installed in accordance with all applicable,

local installation codes, and by a person familiar with the construction

and operation of it, as well as the hazards involved. Inspect item and

contents carefully. If any damage or defect is found, do not install.

Retain all packaging material until installation is complete and approved.

NOTICE:

Fig.1

Fig.2