Service Bulletin, 2021-11-26
X-F270 Installation + Configuration for FIAT Ducato III, Series 8 vehicles (from Q3_2021)
Page 1 of 1 AG, [EN], Rev B
Mounting frame for FIAT Ducato III, Series 8 vehicles
The separately available mounting frame N-XFDUC8 is required for installing the X-F270.
This mounting frame replaces the two-piece metal mounting frame set supplied with the X-
F270 device. The mounting frame N-XFDUC8 is pushed onto the X-F270 device via its back end.
Next, frame is affixed to device applying two M5x6 screws on left and right side.
This pre-assembled combo is used to replace the ex-works mounted frame of the vehicle with
“radio preparation”.
Connection of steering wheel buttons (analog signals, via red mini-ISO connector)
The rear steering wheel buttons (3 buttons each on the left and right side) are connected to
the device via mini-ISO connector, which connects Key1/2/GND over the adapter cable
supplied with the X-F270.
The telephone buttons on the front side of the steering wheel are only present as LIN bus
signals in separate non accessible wires, which prevents telephone button function integration
over the existing analogue wiring. Integration of Telephone buttons is solved with a “double
function assignment” of the rear MUTE button, allowing to accept and end calls over the MUTE
control button located on the steering wheel backside.
The X-F270 device must feature v2.5 software version and up and use of device with Series 8
vehicles requires manual mode switching from MODE1 to MODE 2. With MODE 2 set, device
must be restarted to apply the setup change.
MODE 1 / MODE 2 setup can be found under:
Settings > Other > SWC Assignment > Mode 2 (see picture).
If desired, the telephone buttons on the front side of the steering wheel can be mapped to
the device via separately available SWC interface modules available from different suppliers.
See instructions that come with the interface, for supported button functions and connection
to the IR-In of the XZENT X-F270 (like for example “N-XFDUC8-SWC1”).
1
Stratasys F270 Operation and Maintenance Manual
T-Mobile Octophon F640 Operating Instructions Manual
SBC M-Bus Master Module PCD2.F27x0 & PCD3.F27x Owner's manual
Endres+Hauser BA Cerabar PMP21 IO-Link Operating instructions
SICK SENSICK WT 260 energetic Operating instructions
Manhattan 101639 User manual