2. Clack
  3. Corosex or FloMag pH Filter Media 10 Lb

Clack Corosex or FloMag pH Filter Media 10 Lb User guide

  • Hello! I've reviewed the user manual for the Neutralizer. This document provides clear instructions on how to add replacement media and perform a proper backwash to ensure optimal performance. It emphasizes preventing media from exiting through the drain line during backwash. I am ready to answer your questions about the procedures outlined in the manual.
  • What is the first step before starting the backwash?
    How long does the backwash usually last?
    What should you look for when opening the Inlet valve?
Neutralizer Service: Adding Media Neutralizer Service: Adding Media
www.cleanwaterstore.com Rev 120915 www.cleanwaterstore.com Rev 120915
ATTENTION:
After adding replacement media, a backwash
must be performed to rinse off the media.
When performing this backwash, care must
be taken to ensure that the media does not come
back out the drain line.
BEFORE YOU START THE BACKWASH:
Put the Inlet valve on the bypass assembly to the
OFF/CLOSED position.
Press and hold the button to start the backwash.
When the display starts counting down the backwash
(almost always 10 minutes), open the Inlet valve just a
little, until you see a little water coming out of the drain
line. Open the Inlet valve a little bit more, each time
stopping to look at the drain line, and make sure no
media is coming out. Do this, slowly, until the valve
is completely open and no media is coming out.
Let the valve advance to Rapid Rinse and finish the
backwash cycle.
Now, immediately start another backwash, this time
with the Inlet Valve full open, and no media should come
out. Let it finish this backwash, and you have finished.
ATTENTION:
After adding replacement media, a backwash
must be performed to rinse off the media.
When performing this backwash, care must
be taken to ensure that the media does not come
back out the drain line.
BEFORE YOU START THE BACKWASH:
Put the Inlet valve on the bypass assembly to the
OFF/CLOSED position.
Press and hold the button to start the backwash.
When the display starts counting down the backwash
(almost always 10 minutes), open the Inlet valve just
a little, until you see a little water coming out of the
drain line. Open the Inlet valve a little bit more, each
time stopping to look at the drain line, and make sure
no media is coming out. Do this, slowly, until the
valve is completely open and no media is coming out.
Let the valve advance to Rapid Rinse and finish the
backwash cycle.
Now, immediately start another backwash, this time
with the Inlet Valve full open, and no media should
come out. Let it finish this backwash, and you have
finished.
Neutralizer Service: Adding Media Neutralizer Service: Adding Media
www.cleanwaterstore.com Rev 120915 www.cleanwaterstore.com Rev 120915
/