Instruction
This product includes 6 packages, each of them contains the accessories as
follows:
MH-SF166-1 ——①+⑥+⑦+⑨+⑩+⑪
MH-SF166-2 ——②+⑥+⑦+⑨+⑩+⑪
MH-SF166-3 ——③+⑥+⑦+⑨+⑫
MH-SF166-4 ——③+⑥+⑦+⑨+⑫
MH-SF166-5 ——④+⑤*2+⑧*2+⑬
MH-SF166-6 ——④+⑬
Accessories List
Serial
number
Product
Quantity
Picture
Note
①
Right Seat
1
Imagine sitting down, the right side on
which there should be 5reserved screw
holes for installing the armrest, and the
back side of this right seat on which
there should be 4reserved screw holes
for installing the backrest.
②
Left Seat
1
Imagine sitting down, the left side on
which there should be 5reserved screw
holes for installing the armrest, and the
back side of this right seat on which
there should be 4reserved screw holes
for installing the backrest.
③
Middle Seat
2
④
Ottoman
2
⑤
Left、Right
Armrest
2
⑥
Backrest
4
⑦
Back Cushion
4
⑧
Armrest
Cushion
2
⑨
Small Pillow
4
⑩
Sofa Legs、
Screws
2
Leg*4 Pcs
Bolt*16 Pcs
Screws*9Pcs
Washer*9 Pcs
Nut*9 Pcs
⑪
Buckle
3
Buckle*3 Pcs
Bolt*2 Pcs
⑫
Sofa Legs、
Screws
2
Leg*4 Pcs Bolt*16 Pcs
Screws*4 Pcs
Washer*4 Pcs
Nut*4 Pcs
⑬
Sofa Legs、
Screws
2
Leg*4 Pcs
Bolt*16 Pcs
Installation steps：
A. Pull apart the Velcro from the side on the left seat，and take out all the
parts inside.
B. Install the left seat, armrest and backrest.（read from the note on page
Accessories List to determine the left seat）
1. Insert the long screws into the screw holes of
the armrest and backrest about 1/3 deep, align
with the holes on the seat and push them in,
and then use nuts and washers to fasten from
inside of the seat.
2. Mounting seat feet .
Fasten screws
from inside.
Left Armrest
Backrest
Left Seat
C. Install the right seat(step details are the same as step B).
D. Install the middle seats.
E. Install the ottoman.
1. Insert the long screws into the screw holes
of the backrest about 1/3 deep, align with the
holes on the seat and push them in, and then
use nuts and washers to fasten from inside of
the seat.
2. Mounting seat feet .
Fasten screws
from inside.
Backrest
Middle Seat
F. Apply the connection buckles to connect the seats together(or not, it’s
totally up to users).
G. Seal all the seats bottoms with base cover(pieces of cloth). According to
the approximate positions, cut small holes on the base cover and put through
the legs, attach the cover with the seat bottom with the Velcro.
H. Finished product display：
/
