Symmons S-3501-CYL-B-STN Installation guide

Brand: Symmons

Model: S-3501-CYL-B-STN

Category: Sanitary ware

Type: Installation guide

Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ Phone: (800) 796-6667 ■ Fax: (800) 961-9621

Shower Trim

Operation and Maintenance Manual

Limited Lifetime - to the original end

purchaser in consumer/residential

installations.

10 Years - for commercial/industrial

installations. Refer to

www.symmons.com/warranty for

complete warranty information.

Warranty

1Remove Test Cap

Valve Setup

Installation - Setting Limit Stop Screw

WARNING: Failure to adjust limit stop screw properly may result in serious scalding.

1) Turn hot and cold supplies on. Valve will not operate unless both hot and cold water supply pressures are on.

2) Place handle on ﬂow control spindle and open valve to maximum desired temperature.

3) Turn limit stop screw clockwise until it seats.

Installation - Adjust Rotation Resistance

1) Turn hot and cold supplies on. Valve will not operate unless both hot and cold water supply pressures are on.

2) Place handle over ﬂow control spindle.

3) Tighten packing nut for positive frictional resistance as handle is rotated from shut-o position across adjustment range.

Warnings:

1. Test cap for pressure testing up to 200 psi maximum (for water). DO NOT exceed 200 psi while pressure testing valve body.

2. Do not expose valve with test cap to heat for longer than 2 minutes when soldering copper tubing. Doing so may damage the internal compo-

nents of the valve and will void the product warranty.

3. Ensure test cap is re-torqued to 30 lb-ft after soldering valve body.

2Install Spindle and Cap

Clean ﬁnished trim area with a soft cloth using mild

soap and water or a non-abrasive cleaner and then

quickly rinse with water.

Product Care

Installation Instructions

Tools Required:

Packing Nut

Limit Stop

Screw

For rough-in dimensions refer to submittal

Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ Phone: (800) 796-6667 ■ Fax: (800) 961-9621

Showerhead Installation Shower/Diverter Valve Trim Installation

Hand Shower and Slide Bar Installation

Grab Bar Installation

Wall Cradle Installation

VersaFlex Trim Installation

Plumber's

Tape

Plumber's Tape

For rough-in

dimension refer

to submittal

Screw must be

fastened into

backing board

Screw must be fastened

into backing board

Temptrol Valve

Diverter Valve

Check for

leaks

Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ Phone: (800) 796-6667 ■ Fax: (800) 961-9621

Hand Shower Holder Installation

Tub Spout Installation

For tub spout rough-in dimensions refer to submittal

TUB/ACCESSORY SHOWER/ACCESSORY

INCREASE DECREASE

Operation (VersaﬂexTM Diverter Control)

Turn diverter control handle clockwise to

divert to tub spout or other Symmons acces-

sory.

Turn diverter control handle counterclockwise

to divert to shower or other Symmons acces-

sory.

Operation (Volume Control)

Turn volume control handle clockwise to in-

crease volume.

Turn volume control handle counterclockwise

to decrease volume.

Operation Guide

Don't over

tighten

Warning: Remove

burrs before as-

sembly

Slip On Tub Spout

Thread On Tub

Spout

Plumber's Tape

Symmons Industries, Inc. ■ 31 Brooks Drive ■ Braintree, MA 02184 ■ Phone: (800) 796-6667 ■ Fax: (800) 961-9621

WARNING: This product can expose you to chemicals including lead, which is known to the state of California to

cause cancer, birth defects, or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

1 2 3

Operation (Dual Outlet Diverter Control)

1. Cartridge is factory set to divert to

function 1

2. Turn handle to position 2 to diverter to

function 2

3. Turn handle to position 3 to share

functions 1 and 2

Note: Additional handle positions for same

output are illustrated.

POSITION 1

POSITION 2

POSITION 3

POSITION 4

POSITION 5

POSITION 6

Triple Outlet Diverter Operation

1. Cartridge is factory set to divert

to function 1.

2. Turn handle to position to divert

to function 2.

3. Turn handle to position 3 to divert

to function 3.

4. Turn handle to position 4 to share

functions 2 and 3.

5. Turb handle to position 5 to share

functions 1 and 3.

6. Turn handle to position 6 to share

functions 1 and 2.

12 3

Operation (Temperature Control)

1. Turn shower handle counterclockwise

approximately 1/4 turn to put valve in

cold position

2. Turn shower handle counter-clockwise

approximately 1/2 turn to put valve in

warm position

3. Turn shower handle counter-clockwise

approximately 3/4 turn to put valve in

hot position

Symmons S-3501-CYL-B-STN Installation guide

Brand: Symmons

Model: S-3501-CYL-B-STN

Category: Sanitary ware

Type: Installation guide

Download PDF

report

Symmons S-3501-CYL-B-STN Installation guide

Symmons S-3501-CYL-B-STN Installation guide

Related papers