MODEL: M11879
ASSEMBLY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
READ INSTRUCTIONS ALL THE WAY THROUGH
PRIOR TO ASSEMBLY.
Assembly Time: 10 Minutes.
UNPACK THE SOLAR LED LIGHT STRING
The following parts should be included in your
solar light kits; (3) Solar LED Lights, (1) Solar
panel, (1) Adjustable bracket and stake set, (1)
Spade Bit.
TOOLS
A drill will be required for deck or hard surface
installation.
3.) With the holes in place, slide the LED light
body through the bottom of your deck.
4.) Once threaded through the hole, screw the
lens to the LED body.
5.) Gently pull the string under the deck to
lock into place.
DECK INSTALLATION
1.) Using your drill with the included spade bit,
carefully drill through your deck.
2.) Remove the lens from the body of the LED
light body.
GROUND INSTALLATION
Bury the Solar LED Light String bodies in grass,
mulch, or gravel. You may wish to create a small
trench between lights in order to conceal the
cable.
TIP:
Use your drill and the included spade bit for
greater precision.
PANEL ASSEMBLY AND INSTALLATION
Timer
4.) Once charged for 6~8 hours, your LED Light
String is ready for use. Press the power button on
the back of the unit to turn the lights on.
MODEL: M11879
ASSEMBLY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
1.) Securely join the tube and stake together.
2.) Attach the bracket to the solar panel as
illustrated in the figure below. Please note, the
angle of your solar panel can be adjustable at
any time by loosening the screw, and locking it
into a new position.
3.) Insert the solar panel into the ground.
SETTING THE TIME DURATION
By pressing the timer switch you can select from
(3) duration modes.
A. 4 Hours
B. 5 Hours
C. 6 Hours
While pressing the timer switch you can cycle
through each mode-the duration is indicated by
the number of times the LED lights flash.
4 Hours = 4 Sequential Flashes
5 Hours = 5 Sequential Flashes
6 Hours = 6 Sequential Flashes
TROUBLE SHOOTING
MODEL: M11879
ASSEMBLY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
1.) If your Solar LED Light is not functioning
properly, or losing power mid-cycle, ensure the
solar panel is correctly positioned in direct
sunlight. Your solar panel will need to collect
between 6 ~ 8 hours of sunlight to function
throughout a full cycle.
2.) Check your connections to the solar panel - a
loose or improperly connected cable will cause
the LED Light String to malfunction.
3.) Although the battery inside your Seriously
Solar panel is designed for maximum longevity,
overtime performance will drop - replacing the
battery will correct this issue.
4.) If the LED Light still does not work, please
call 904-642-4340 for customer service. Do Not
Return to place of purchase.
IMPORTANT NOTES
1.) The LED Light will operate for 8 continuous
hours if turned on manually without identifying a
program cycle.
2.) The LED Light will turn on automatically
each night - no need to program a operating time.
/
