Nokia Asha 230 Dual SIM RM-987 User manual

Send feedback

Recommend Change in

KICS

Rate this page in KICS

E-mail

[email protected]

Service Manual for L1 and L2

Nokia Asha 230

Nokia Asha 230 Dual SIM

RM-986(DS), RM-987(SS

)

Key features



2.8" display with 320 x 240 resolution



1.3 Mpix camera



Quick photo sharing



Dual SIM support (RM-986 only)



Micro SD card support up to 32 GB

Version 1.0

CHECK THE REPAIR

POLICY BEFORE

PERFORMING ANY

MECHANICAL REPAIR ON

SERVICE LEVEL 1&2!

Exploded view Disassembly steps

Assembly hints Solder components Service devices

Product controls and interfaces Service concept

More More

More More More

More More

Service Manual Level 1 an

d

2

Nokia Asha 230, Nokia Asha 230 Dual SI

M

RM-986(DS), RM-987(SS)

V

ersion 1.0

Version histor

y

Version Date Description

1.0 27.02.2014 First published version

Service Manual Level 1 and 2

Nokia Asha 230, Nokia Asha 230 Dual SIM

RM-986(DS), RM-987(SS)

Version 1.0

Exploded view

A-COVER

I0001

EARPIECE ADHESIVE

I0003

DISPLAY CONDUCTIVE TAPE

I0010

CAMERA

I0012

SIM LID

I0015

BATTERY COVER

I0020

BT ANTENNA

I0014

TOUCH IC GASKET

I0006

EARPIECE

I0004

RF SHIELDING LID

I0009

TOUCH PANEL

I0002

DISPLAY

I0005

TYPE LABEL

I0011

BB SHIELDING LID

I0008

LIGHT SWAP PWB

I0007

SPEAKER

I0017

D-COVER

I0016

SPEAKER MESH WITH GASKET

I0013

MAIN ANTENNA

I0018

SCREW TORX+

SIZE 6 RF1.6 x 4.5

I0019

D-COVER ASSEMBLY

(I0013 - I0016)

3

A-COVER ASSEMBLY

(I0001 - I0004)

1

LIGHT SWAP PACKAGE

(I0006 - I0011) 2

Only available

as assembly

Not reuseable

after removal

Repair/swap

only in level 3

Service Manual Level 1 and 2

Nokia Asha 230, Nokia Asha 230 Dual SIM

RM-986(DS), RM-987(SS)

Version 1.0

Disassembly steps

1) For disassembling you need the Nokia Standard toolkit version 2. You will also need the camera

removal tool SS-276.

2) Protect the TOUCH PANEL with protective film.

3) Pull from the shown corners and push from the middle of the BATTERY COVER to release it. Remove

the BATTERY COVER.

4) Unscrew the four Torx+ size 6 screws in the order shown.

5) Insert the SRT-6 to shown corner to release the shown clip holding the D-COVER.

6) Use the SRT-6 to release the two shown clips.

7) Release also the clip on the bottom end of the device.

8) Release the two shown clips on the right side of the device.

9) The D-COVER can now be released.

10) Push from the shown place with the sharp end of the SS-93 to release the MAIN ANTENNA.

11) Push the SS-93 under the MAIN ANTENNA to release it. Remove the MAIN ANTENNA.

12) Clean the MAIN ANTENNA adhesive remains from the D-COVER. Do not use them again.

13) Release the SPEAKER with the dental tool.

Be careful not to injure yourself with the sharp end of the dental tool.

14) Release the SPEAKER MESH WITH GASKET with the dental tool. Remove it with tweezers. Discard it.

15) Open the DISPLAY connector with the SS-93.

Be careful not to damage the connector or any nearby components.

16) To remove the A-COVER release the shown clip with the SS-93.

17) Release also the second clip holding the A-COVER.

18) The A-COVER can now be separated.

19) Protect the other side of the TOUCH PANEL with protective film.

20) Protect the DISPLAY with protective film.

21) Release the EARPIECE with the dental tool. Remove it with tweezers. Do not use the EARPIECE again.

Discard it.

22) Remove and discard the EARPIECE ADHESIVE.

23) Push the SS-93 under the DISPLAY from shown side. Slowly push the SS-93 towards the bottom end

release the DISPLAY.

Be careful not to damage the DISPLAY.

24) Remove the DISPLAY.

25) Use the SS-93 to release the two DISPLAY CONDUCTIVE TAPES. Remove them with tweezers. Do not

use them again. Discard them.

26) Use the dental tool to lift up the TOUCH IC GASKET. Remove and discard it.

27) Use the camera removal tool SS-276 to remove the CAMERA. Note the alignment of the tool. Place

the SS-276 on top of the CAMERA and push it down. Then press and hold the button on the SS-276 to

lock it to the CAMERA.

28) Lift up the SS-276 and remove the CAMERA.

29) Use the SS-93 to peel off the TYPE LABEL. Remove and discard the TYPE LABEL.

30) Nokia Asha 230 / Nokia Asha 230 Dual SIM disassembly procedure is complete.

-END OF DISASSEMBLY-

Service Manual Level 1 and 2

Nokia Asha 230, Nokia Asha 230 Dual SIM

RM-986(DS), RM-987(SS)

Version 1.0

Assembly hints

Fasten the four shown Torx+ size 6 screws to the torque of 14Ncm.

Service Manual Level 1 and 2

Nokia Asha 230, Nokia Asha 230 Dual SIM

RM-986(DS), RM-987(SS)

Version 1.0

Solder components

V

R2751

R2750

F3300

J7401

R3200 V1025

X1002

X7451

X7453

J7400

V2201Z3301

X7450

X7452

V2207

V6100 S1001 S1002

V2221

Grounding

spring

Grounding

spring

Touch panel

connector

USB

fuse

2nd SIM

ASIP

USB

transistor

USB EMI

filter

USB

transistor

MicroSD

ASIP

Display

transistor

Battery

transistor

Battery

transistor

Antenna

spring

Antenna

spring

Antenna

spring

Lock/Power

switch

Vol/Zoom-

switch

SIM

ASIP

Vol/Zoom+

switch

Grounding

Spring

Grounding

spring

Grounding

spring

TOP

BOTTOM

Page is loading ...

Nokia Asha 230 Dual SIM RM-987 User manual

This manual is also suitable for

Nokia Asha 230 Dual SIM RM-987 User manual

Related papers

Other documents