Page is loading ...
Champion Power Equipment
23 Ton Log Splitter
Model 92301 9-14-2012
Issue:
Wheel bearings are difficult to install on the Axle.
Cause:
The Bearing and Axle dimensions are near the edge of their
tolerance. This may cause a slight interference fit (.0004” max).
This bearing fit is acceptable and will not have any adverse effect
on the product performance or warranty.
Solution:
If Bearings are difficult to install, follow the assembly instructions
below.
Tools Needed :
• 1” Pipe x 8” long (with Coupling if bigger hitting area is desired)
• Hammer (about 28 oz)
NOTE:
If a Bearing is damaged during this installation process, it
will be replaced at no cost. Replacement Bearings are
available from the Champion Power Equipment office in
Santa Fe Springs, CA, 877-338-0999.
92301 - Wheel Bearing
Instalaltion, 9-14-2012
2. Slide the Bearing Dust Cover on the Axle as shown below.
1. Use the 1” pipe (or wood block) to remove the dust cover on
the inside of the wheel hub.
92301 - Wheel Bearing
Instalaltion, 9-14-2012
4. Use the 1” Pipe and Hammer to tap the Bearing onto the Axle.
The 1” Pipe will only contact the inner race of the Bearing.
3. Position the Bearing squarely on the Axle with larger diameter
going on first.
92301 - Wheel Bearing
Instalaltion, 9-14-2012
6. Position the Bearing squarely on the Axle with smaller diameter
going on first. Use the 1” Pipe and Hammer to tap the Bearing
onto the Axle.
5. Position the Wheel on the Axle.
The inside hub should seat against the inside Bearing .
7. Install the Castle Nut and tighten to fully seat the Bearing.
Continue with assembly according to the Operator manual.
92301 - Wheel Bearing
Instalaltion, 9-14-2012
/
