Futuro Futuro IS60RECANO Installation guide

Type
Installation guide

This manual is also suitable for

Futuro Futuro
Futuro Futuro
RANGE HOOD
INSTALLATION MANUAL
MODEL: RECANO ISLAND
(40” & 60” VERSIONS)
NOTE: PRIOR TO INSTALLATION
Please inspect range hood visually,
as well as connect it to power supply
and test its operation.
Recommended
Installation Height
1
26” - 28”
from cooktop
to bottom
of hood
NOTE: Inch dimensions are approximate, and given for reference / convenience only.
Always measure the actual items on-site and make drilling / cutting marks according to
actual materials & measurements.
MOUNTING PLATE DIMENSIONS
NOTE: Inch dimensions are approximate, and given for reference / convenience only.
Always measure the actual items on-site and make drilling / cutting marks according to
actual materials & measurements.
MOUNTING PLATE SPACING
2
3
105mm (4 1/8”)
105mm (4 1/8”)
40” WIDE VERSION 60” WIDE VERSION
901mm (35 1/2”)
1300mm (51 3/16”)
1401mm (55 1/8”)
800mm (31 1/2”)
105mm (4 1/8”)
98mm (3 7/8”)
49mm (2”)
49mm (2”)
15mm
(9/16”)
68mm (2 11/16”)
68mm (2 11/16”)
1.) Drill holes in ceiling / joists / plywood, to match holes in mounting plates.
2.) Attach mounting plates to ceiling, using the provided screws & washers.
NOTE: Concrete / masonry ceilings ONLY - use anchors as needed.
ATTACH MOUNTING PLATES TO CEILING
4
1.) Locate cover panels on top of range hood.
2.) Remove screws holding panels in place.
3.) Remove panels.
REMOVE PANELS FROM HOOD
5
1.) Locate the power cord.
2.) Thread power cord through hole in
range hood body, as shown.
PREPARE POWER CORD
6
1.) Slide horizontal trim plate onto vertical rod covers.
2.) Slide rod covers onto threaded rods.
3.) Secure bottoms of rods with brackets, washers and nuts.
ASSEMBLE SUPPORT STRUCTURE
7
Thread the power cord through the brackets,
through the provided hole next to
center screw, and run it vertically
through the support rail, as shown.
BRING POWER CORD TO CEILING
8
Connect the power cord to the power line
in the ceiling, in accordance with your
local building codes.
CONNECT POWER CORD TO POWER LINE
9
1.) Raise hood body and slide mounting screws into
matching holes on support brackets.
2.) Secure hood to both bracket with screws.
ATTACH HOOD TO SUPPORT BRACKETS
10
1.) Replace the cover panels
(that were removed in Step 5.)
2.) Secure panels with original screws.
REPLACE COVER PANELS
Adjust the vertical level with screws.
LEVEL TOP BRACKETS
11
12
1.) Raise the trim plate to the upper brackets.
2.) Secure trim plate with screws, as shown.
Check the functions of the range hood
to ensure proper operation.
ATTACH TRIM PLATE
CHECK RANGE HOOD
13
15
Install the supplied filter
package, as shown.
INSTALL FILTER PACK
14
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Futuro Futuro IS60RECANO Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI