Schlage J Strap - Sliding Door Barn Door Hardware - 8ft Installation guide

Type
Installation guide
© Allegion 2017
111828 Rev. 09/17
Customer Service
1-888-805-9837 www.schlage.com
8’ Rail Length
J STRAP SLIDING DOOR HARDWARE
2 11
10 3
-3/16”
(5.5 mm)
-5/16”
(8 mm)
-3/8”
(10 mm)
-3/8”
(10 mm)
ANCHOR (x6)
Ø10
ANCHOR (x4)
Ø8
ANCHOR (x2)
Ø8
SCREW (x4)
ST4.2x35
PLUG (x4)
HANGER
TEMPLATE (x1)
HANGER (x2)
WASHER (X6)
NUT (x4)
SCREW, M10 X 55mm (X2)
BOLTS for 35-40mm door
SCREW, M10 X 60mm (X2)
BOLTS for 40-45mm door
(If using Floor
Guide )
SCREW (x6)
M8x90
WASHER, 8mm (X8)
10
4 9
RECOMMENDATIONS
Review all instructions before beginning installation.
Two-person installation.
Use non-scratch tools on exterior surfaces.
NOTE: If the opening width is greater than 1219 mm, or for
bi-parting door, connect two tracks with the Track Adaptor.
Install one track, connect with adaptor, then install other track.
8 5
(25 mm)
Use the instructions below as a remedy
if the Door Stop needs to be installed
inside the Track Fastener.
6 7
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Schlage J Strap - Sliding Door Barn Door Hardware - 8ft Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI