Ergotech Group 100-D28-B11 Installation guide

Brand
Ergotech Group
Model
100-D28-B11
Category
Flat panel desk mounts
Type
Installation guide
OCT-08 www.ergotechgroup.com
ERGOTECHGROUP,INC.
8WestchesterPlaza
Elmsford,NY10523
91434
7
3800
Special Interest
Articles:
• Add a highlight
or your point of
interest here.
• Add a highlight
or your point of
interest here.
• Add a highlight
or your point of
interest here.
To adjust monitors:
Left/Right and Up/Down
: Grasp monitor with both hands and adjust to desired position.
To tension the vertical adjustment to the weight of monitor:
Tighten the 5mm bolt on the right side of the pivot
with the hex wrench provided.
To remove monitor:
Take the weight from the monitor with one hand on the bottom and tip back slightly while
using the other hand to lift the top of the silver release button. Lift up and back and this will release the monitor
from the stand.
Installation Instructions
Product # 100-D28-B11 – Dual Vertical Desk Stand
1. Check to see that small hex set screw at rear of
base is backed out enough to allow pole to seat
down completely. Insert pole into base. Tighten set
screw, using 3mm Allen key provided..
2. Loosen ratchet type handle on pole clamp monitor
mounting block. Slide clamp and block down pole
and tighten. Repeat for upper assembly.
Note:
position along pole will depend on size of
monitors being mounted. These heights can be
adjusted after the monitors are mounted.
3. Attach quick release pivots to back of each monitor
with screws provided. Be sure that silver release
button is toward the top of the monitor.
4. Place each monitor on its mounting block by
tipping back approximately 45 degrees and then
down until the silver release button engages hole
on block. It will click into place.
5. Repeat for upper monitor.
  • Page 1 1

Ergotech Group 100-D28-B11 Installation guide

Brand
Ergotech Group
Model
100-D28-B11
Category
Flat panel desk mounts
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents