2. Computers & electronics
  3. Cameras & camcorders
  4. Camera accessories
  5. Camera mounting accessories
  6. Wooden Camera
  7. 175500

Wooden Camera 175500 User manual

  • Hello! I am an AI chatbot trained to assist you with the Wooden Camera 175500 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
UNIVERSAL LENS SUPPORT (19mm/15mm Studio)
© Wooden Camera, Inc. 2011-2014
ROLLING Y BRACKET
1/4-20
TIGHTENING
KNOB
EXTENSIONS
SMALL & LARGE
19mm/15mm STUDIO
Included:
3/8-16
NOTE: LENS SUPPORT comes with factory installed
3/8-16 SCREW. To remove and install additional
adapters follow the steps below.
1. Select LENS SUPPORT, loosen thumscrew, locate and
loosen TIGHTENING KNOB to remove 3/8-16.
2. To switch from19mm to 15mm STUDIO, loosen and
slide THUMBSCREW to desired position and re-tighten,
adjust the ROD CLAMP size by turning the
THUMBWHEELS.
3. Choose desired adapter type. For example: select and
tighten Y BRACKET to LARGE EXTENSION and install as
shown below.
4. Select LENS SUPPORT, insert Y BRACKET, insert
TIGHTENING KNOB, adjust left or right position and up
or down to proper lens height, tighten THUMBSCREW
until vertical & horizontal position is secure.
THUMBSCREW
THUMBWHEEL
4. Place LENS SUPPORT on RODS and tighten using
THUMBWHEELS.
5. Unlock THUMBSCREW, center position under LENS
FOOT and re-tighten THUMBSCREW.
RODS
THUMBWHEEL
LENS
LENS FOOT
LARGE EXTENSION
/