R82 High-low Frame Assembly Instruction

Brand
R82
Model
High-low Frame
Category
Coffee making accessories
Type
Assembly Instruction

This manual is also suitable for

Monteringsvejledning (DK)
Montering af pedal
Mounting instruction (GB)
Mounting the foot pedal kit
Rev. 002 - 08.2009
9996097709
Montage instructies (NL)
Monteren van voetpedalen (aan weerszijden) op de High-low:x onderstellen
Montageanleitung (DE)
Montage des Fußpedals für High-low Gestelle
Monteringsanvisning (N)
Montering av pedal
Page is loading ...
Page is loading ...
A
B
D
C
G
F
E
H
I
J
K
Mounting instruction
Mounting foot pedals on High-low:x frames
Remove the gas spring:
* Remove the bolt (A) and loosen the lock nut (B).
* Unscrew the gas spring.
Remove the old fitting:
* Remove the bolts (C) and the pedal-fitting (D).
Mount the new pedal:
* Mount the new fitting (E) loosely with the enclosed screws (F).
Make sure that the screws (F) are mounted into the same holes
(K) as with the old fitting.
* Place the pedal i the fitting as shown on the drawing (G).
* WHen the pedal points in the right direcion, you fit the small
'banana'-plates (H) med 5 mm screws.
* The spring (I) is placed in the small hole by the joint of the under-
neath of frame.
Mount the gas spring:
* Screw the gas spring back into the release house. Make sure that
the pin hits the curved part (J).
* Tighten the lock nute (B) and the bolt (A).
* Tighten the new bolts (F).
Make sure that the frame can be adjusted up and down. Adjust
the gas spring if necessary, as described in the manual for the
x:panda.
Page is loading ...
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

R82 High-low Frame Assembly Instruction

Brand
R82
Model
High-low Frame
Category
Coffee making accessories
Type
Assembly Instruction
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents