LRS 2AB6OTR7400 User manual

Type
User manual

This manual is also suitable for

TR-7400 Description
The TR-7400 is designed to booster a transmitter’s signal and “retransmit” the same signal.
The unit comes with the following items:
• The main unit
• 1 right angle antenna
• 12-Volt power supply
Connecting the Antenna
The 3” right angle antenna should be placed on the silver barrel on the side of the main unit,
twisted and locked into place (see picture)
Long Range Systems 1TR-7400 Quick Guide
TR-7400 Transmitter- Receiver
Paging Transmitter Repeater System
QUICK SETUP & OPERATION
Transmit
Power
9VAC
800.437.4996
www.pager.net
CONDOR
CLASS 2 TRANSFORMER
(408)745-7141
INPUT: AC 12OV 60Hz 19w
OUTPUT: AC 9V 1800mA
P/N: A91A8
RoHS
UU
LL
LISTED
C
MODEL: 48A -9- 1800
EIA 363 0635 S
MADE IN CHINA
AC Power Outlet
10V Power
Adapter
Antenna
Main Unit
Positioning and Installing the Booster
Note: The best place to mount your Booster is on a ceiling or wall that is very high. The
idea is to get the signal as high as possible so it “umbrellas” the guest and thus all
pagers can receive it.
The booster operates at its best when installed at the “fringe” of your area. This means you
should get it as far from the transmitter as possible but still be able to receive the transmitter’s
signal.
1. Locate a 110V outlet near the selected installation location.
2. Plug the power adapter into the outlet and into the power connector hole on the
side of the unit.
3. Ensure that when power is plugged in, the Red RECEIVE light will blink continu-
ously to indicate power is on and the unit is operating.
4. Place the paging transmitter in “Range Test Mode(see transmitter’s operating in-
structions).
5. Ensure the Red TRANSMIT light periodically alternate flashes on about every 5
seconds.
• If the periodic TRANSMIT flash does not occur, move the booster unit closer to
the transmitter and try again.
• Keep moving the booster toward the transmitter until the TRANSMIT flash oc-
curs.
• After establishing the correct distance, mount the booster as high as possible
Normal Range
Transmitter
TR-7400
Extended Range
SETUP
MGR1
MGR2
STAFF
CLEAR
ENTER
1
2
3
4
5
6
7
8
9
0
ABC
DEF
GHI
JKL
MNO
PQR
STU
VW
XYZ
[
T7400A
Long Range Systems
800.437.4996
F1
F2
F3
F4
Transmit
Power
9VAC
800.437.4996
www.pager.net
:
:
Long Range Systems 2TR-7400 Quick Guide
System Specification
Required voltage: One 110V outlet for the pager keypad.
Operating Frequency: 467.75 MHz
Radiated Power <120mW
Operating Range: Dependent upon pagers used and topography and environment.
Long Range Systems, LLC reserves the right to make changes without further notice to any products herein.
Long Range Systems, LLC makes no warranty, representation or guarantee regarding the suitability of its prod-
ucts for any particular purpose, nor does Long Range Systems, LLC assume any liability arising out of the appli-
cation or use of any product or circuit, and specifically disclaims any and all liability, including without limitation
consequential or incidental damages. “Typical” parameters that may be provided in Long Range Systems, LLC
data sheets and/or specifications can and do vary in different applications and actual performance may vary
over time. All operating parameters, including “Typicals”, must be validated for each customer application by
customer’s technical experts. Long Range Systems, LLC products are not designed, intended, or authorized for
use as components in systems intended to support or sustain life, or for any other application in which the failure
of the Long Range Systems, LLC product could create a situation where personal injury or death may occur.
Should Buyer purchase or use Long Range Systems, LLC products for any such unintended or unauthorized ap-
plication, Buyer shall indemnify and hold Long Range Systems, LLC and its officers, employees, subsidiaries, af-
filiates, and distributors harmless against all claims, costs, damages, and expenses, and reasonable attorney
fees arising out of, directly or indirectly, any claim of personal injury or death associated with such unintended or
unauthorized use, even if such claim alleges that Long Range Systems, LLC was negligent regarding the design
or manufacture of the part, device or system.
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired opera-
tion.
2. Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
RF warning statement:
The device has been evaluated to meet general RF exposure requirement of a mobile device. It is
designed to operate and should be placed in an area with a minimum separation distance to nearby persons of
at least 20 Centimeters.
Long Range Systems, LLC
4550 Excel Parkway, Suite 200, Addison, TX 75001
www.pager.net 214.553.5308
Long Range Systems 3TR-7400 Quick Guide
XU-0055 061014
  • Page 1 1
  • Page 2 2
  • Page 3 3

LRS 2AB6OTR7400 User manual

Type
User manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI