WarmlyYours SCA-DUAL Controller Product information

  • Hello! I have reviewed the provided wiring diagram for the WarmlyYours SCA-DUAL PD PRO Advanced Control. This document outlines the wiring connections for direct connection to heating cables or rolls, including power input, heater loads, and optional temperature and remote controls. I'm ready to assist you with any questions you have about this diagram and the product.
  • What is the maximum load for the heater?
    What is the input power requirement?
    Is it essential to connect sensors in a specific way?
AUX
AUX
REMOTE
REMOTE
RED
WHITE
BLACK
RED
WHITE
BLACK
OPTIONAL
TEMPERATURE
SENSOR WIRING
OPTIONAL
REMOTE CONTROL
WIRING
SENSOR CABLES
(IT DOES NOT MATTER
WHICH OF THE
SENSORS IS WIRED
INTO WHICH SET OF
TERMINALS.)
TERMINAL BLOCK FOR SYSTEM
CABLES AND WIRING
INPUT POWER
100-277 VAC; 50/60 HZ
LINE/BLACK
NEUTRAL/WHITE
GROUND/GREEN
TO HEATER CABLE
100-277 VAC; 30 AMP MAX LOAD
HEATER LOAD 1/BLACK
HEATER LOAD 2/YELLOW OR RED
HEATER GROUND/GREEN
RCO
GTR-SS
GREEN
YELLOW
YELLOW OR REDBLACK
WIRING DIAGRAM
SCA-DUAL (PD PRO) ADVANCED CONTROL
DIRECT TO HEATING CABLE/ROLL
Installation Support • (800) 875-5285 • www.WarmlyYours.com
AIR-SS-2
/