The heating elements should
ONLY be affixed to the middle of
the seat. DO NOT drape over the
front of the seat. The fold at the
seam may damage the unit.
OK to shorten entire element on
NON power cord side
OK to cut between tape area.
Element will heat up above and
below that cut area
Use the supplied tape to cover
the edges of cut area
Do NOT cut vertically along
element. It will not heat up on
either side of the element
OK to shorten entire element on
NON power cord side
NOTE:All wiring should be routed
out the rear of the seat.Do NOT
route wiring down the front or
sides of the seat
The heating elements should ONLY be affixed to the middle of the seat. DO NOT drape over the front of the seat. The fold at the
seam may damage the unit.
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/