Page is loading ...
Securing the Charging Station
This kit provides washers and screws for securing a charging tray to a table
or other surface. Use two kits for the NCS8. Please refer to the NCS mounting
template for screw hole placement.
Important: The top of the screw must extend exactly ⁹/₆₄ (0.149) inches
(3.78 mm) above the surface (about 4½ threads).
• Use the screws that best fit the thickness of the table.
• Use a lock washer and flat washer for each screw.
• If necessary, counterbore the screw head or add additional flat washers.
Use counterbore and washers as necessary depending on thickness of table
0.149” (3.78 mm)
Required Thread Exposure
Use counterbore and washers as necessary depending on thickness of table
NCS8
36.6 mm
[1.441”]
126.6 mm
[4.984”]
51.4 mm
[2.025”]
201.4 mm
[7.931”]
291.4 mm
[11.474”]
141.4 mm
[5.568”]
>40 mm [1.57”]
>40 mm [1.57”] >40 mm [1.57”]
NCS4
36.6 mm
[1.441”]
126.6 mm
[4.984”]
51.4 mm
[2.025”]
141.4 mm
[5.568”]
21.8 mm
[0.858”]
120.0 mm
[4.726”]
51.1 mm
[2.013”]
NCS2
Leave space behind the charger for cabling
NCS Mounting Template
1/1©2017 Shure Incorporated
MXW-NCS
Charging Tray Screw Kit
/
