Barco E-3620 User guide

Type
User guide
Installation procedure
To install the protective screen
Proceed as follows:
1 Important: Put on the gloves included in the packaging to avoid
fingerprints on the protective screen.
2 Put the display in portrait orientation.
3 Peel off the protective film from both sides of the protective screen.
4 Apply the suction cup included in the packaging to the center of the
protective screen.
5 Position the bottom of the protective screen in the opening between the
bezel and the bottom of the LCD panel (see figure 1).
6 Push the top side of the protective screen forward while pulling the suction
cup backward, so that the protective screen bends (see figure 2).
7 Slide the top side of the protective screen in the opening between the bezel
and the top side of the LCD panel while slowly releasing the suction cup
(see figure 3).
Figure 1 Figure 2 Figure 3
8 Carefully remove the suction cup. Clean any marks from the suction cup on
the protective screen.
To remove the protective screen
1 Apply the suction cup to the center of the protective screen.
2 Pull the suction cup so the protective screen pops out of the bezel.
3 Carefully remove the suction cup. Clean any marks from the suction cup on
the protective screen
Cleaning instructions
Clean the protective screen with a lint-free, nonabrasive cloth. The cloth can be
lightly moistened with water or a cleaning solution containing no ammonia.
www.barco.com
B4100453-01
Barco n.v.
President Kennedypark 35
B-
8500
K
o
r
t
ri
j
k
,
B
e
l
g
i
u
m
  • Page 1 1

Barco E-3620 User guide

Type
User guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI