K:\Leaflets\Product Instructions\Butler Bell Instructions 2006.doc
Broughtons BUTLERS BELL Installation Guide
Model Y6004
The Broughtons BUTLERS BELL is designed to operate with any Mechanical Bell pull (supplied separately)
Kit Contents:
1 x Bell with preload spring
1 x Primary Pulley
2 x Secondary Pulleys
1 x Angle bracket for pulley
10M of Nylon Cord
Fitting instructions and screws and wall plugs.
Please telephone 0116 234 1888 to report any items are missing.
The Broughtons BUTLERS BELL has been assembled for operation so the CORD will come from the left or right.
• Take a moment to determine the location and number of pulleys required in relation to the final height and location of the BELL.
• Locate the Primary Pulley Plate in line with the incoming cord.
• The cord should not touch any part of the wall, simply run it from the bell PULL (supplied separately) through the wall and
through the eye of the Primary pulley plate, then screw the Primary plate to the wall.
• Feed the cord round the pulley one complete turn.(as a temporary measure)
• Installing the secondary pulley : -
If you are in any doubt about the method of fixing then you are strongly advised to employ and competent joiner or builder to do the work for you.
Please contact a member of our sales team for any further installation help.
Broughtons of Leicester Ltd, Tel. +44(0)116 234 1888 Fax. +44(0)116 234 1188
K:\Leaflets\Product Instructions\Butler Bell Instructions 2006.doc
Installing the secondary pulley(s)
Example Installation Fig.1
The Secondary Pulley should be directly above the
Primary plate as shown - use the ANGLE plate to
mount the Pulley in-line with the BELL
Ensure the CORD will run directly horizontal to the
top of the BELL arm. Secure the Pulley to the Angle
Bracket using the machine screw required. Fix the
ANGLE BRACKET to the wall. Feed the CORD
around the Pulley and from there to the next pulley,
if required, or directly to the top of the BELL arm.
Fig 1
Example installation Fig.2 & Fig.3
The Secondary Pulley(s) should be mounted in-line with
the BELL position.
Various other installations are possible to cover
corners/reveals etc. Fit the BELL via the back plate to the
wall in the desired location – ensuring the cord travels on
straight to the Bell Fig 3.
Secure the Cord to the Bell Arm
Ensuring that the Cord is taut, feed the cord through
the eyes at the top of the Arm and tie a knot, so that
the correct tension is available for operation.
Fig 2
Fig 3
Trouble Shooting:
If after completing the above instructions, a poor ringing sound is the result, ensure:
• The Cord is not wrapped around each pulley one complete turn
• The Cord is not tight between each pulley
• There isn’t enough tension on the cord to pre-load the inner spring.
Please contact a member of our sales team for any further installation help.
Broughtons of Leicester Ltd, Tel. +44(0)116 234 1888 Fax. +44(0)116 234 1188 [email protected]
/
