Air Hogs sky commander Assembly Instructions

Brand: Air Hogs

Model: sky commander

Type: Assembly Instructions

Air Hogs sky commander is a toy helicopter that can fly to heights of up to 50 feet (15m) and is powered by the NEW R.A.I.D. IV™ Inline Engine, Sky Commander is packed with power for awesome climbs, spins, and maximum vertical flight. It launches straight out of your hand and best of all… no batteries required…Just Pump it Up!

IMPORTANT

PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE FLYING!

1-800-622-8339

AIR HOGS

SKY COMMANDER

flies to heights of

up to 50 feet (15m)! Powered by the NEW R.A.I.D. IV™

Inline Engine, Sky Commander is packed with power

for awesome climbs, spins, and maximum vertical flight!

Launches straight out of your hand! Best of all…

no batteries required…Just Pump it Up!

SIDE ELEVATION

DOCKING STATION/PUMP

NOZZLE

PUMP HOSE

BASE

PUMP HANDLE

PLEASE DO NOT RETURN AIR HOGS® TO THE STORE.

CALL OUR FRIENDLY FLIGHT TECHNICIANS TOLL-FREE AT:

Getting To Know Your AIR HOGS

SKY COMMANDER

1 Helicopter

1 Pump

1 Spare Tail Wing

1 Rotor

1 Set of Stickers

Check to make sure the contents are

complete:

ROTOR MOUNT

ROTOR

TAIL ROD

TAIL WING

TAIN WING HOLDER

ROTOR PORT

BASE

AIR INTAKE

FUSELAGE

PUMP SHAFT

Assembly Instructions & Flight Manual

Item# 45049 REV 0

SKY COMMANDER

FLYING YOUR AIR HOGS® SKY COMMANDER™

ALWAYS FLY YOUR HELICOPTER A WIDE OPEN GRASSY

AREA;THIS WILL ENSURE A LONGER LIFE FOR YOUR HELICOPTER.

ALWAYS USE CAUTION WHEN FLYING YOUR HELICOPTER! ALWAYS POINT YOUR HELICOPTER AWAY FROM YOUR FACE AND OTHER

PEOPLE WHEN LAUNCHING!

DO NOT FLY THE HELICOPTER IN VERY WINDY CONDITIONS. DO NOT FLY THE HELICOPTER IN TEMPERATURES BELOW 45˚F / 7˚C;

THE WINGS WILL BECOME BRITTLE AND MAY BREAK, AND ENGINE PERFORMANCE WILL DECREASE.

PUMPING

A) Push Sky Commander’s AIR INTAKE

onto the PUMP NOZZLE. Ensure that

you push the nozzle ALL THE WAY

inside the AIR INTAKE.

B) Place both feet on pump base and

grasp pump handle.

C) PUMP 50 TIMES to reach MAXIMUM

AIR PRESSURE.

D) Remove the helicopter from the pump.

PUMPING TIP:

Pump slowly and always pull the pump

handle ALL THE WAY up and push it ALL

THE WAY down with each pump stroke.

Short pump strokes will not force enough

air into the helicopter’s tank, and it may

not fly well.

AIR INTAKE

PUMP

NOZZLE

CONTINUED....

HOW TO ASSEMBLE YOUR AIR HOGS® SKY COMMANDER™

Snap ROTOR PORT onto ROTOR MOUNT. PUSH

DOWN HARD.

IMPORTANT:THE ROTOR IS A ONE-TIME ASSEMBLY.

ONCE THE ROTOR IS ATTACHED TO THE HELICOPTER,

YOU WILL NOT BE ABLE TO REMOVE

IT WITHOUT CAUSING DAMAGE TO THE TOY.

Slide the TAIL WING into the TAIL WING HOLDER

and COVER WITH MYLAR TAPE ON BOTH SIDES

(included) as shown. Be careful not to create

creases, as creases may adversely affect flight

performance.

Item# 45049 REV 0

SELECT A GOOD FLYING LOCATION:

Always fly in a wide-open area, with lots of grass for soft landings.

Do not fly near overhead wires, buildings, trees, or other

obstructions.

CHECK THE WEATHER BEFORE FLYING:

It is best to fly on a warm and sunny day with low-mild wind.

Do not fly in poor weather conditions such as electrical

storms, rain, snow, sleet, or fog.These conditions are unsafe

for flying and may cause damage to the toy and/or personal

injury.

Do not fly on very cold days.Temperatures below 7°C/45°F

may result in poor flight

performance and/or damage

the toy. The engine and the

foam parts of the product

are affected by extremely

cold temperatures and may

become damaged.

FLYING YOUR AIR HOGS® SKY COMMANDER™ Continued

A) Place helicopter in your launching hand,

as shown.

B) Extend your launching hand far away from

your face and body.

C) Use your other hand to spin the ROTOR in

the direction of the ARROW(S).

This activates the engine.

D) Give Sky Commander™ a GENTLE TOSS

STRAIGHT UPWARD and release into the air.

DO NOT LAUNCH ON AN ANGLE!

E) After your last flight, spin the rotor to ensure

all of the remaining air in the AIR TANK has

been used up.

Do NOT leave air in the tank after flying.

HOW TO STOP THE ROTOR FROM SPINNING:

To stop the rotor from spinning, gently touch

the helicopter’s rotor to the ground.

LAUNCHING:

Item# 45049 REV 0

REPAIR CENTER

If the tail on your AIR HOGS® SKY COMMANDER™ becomes

damaged, repair it by using clear tape.

CLEAR TAPE

PROBLEM

SOLUTION

TROUBLESHOOTING GUIDE

Engine will not start.

Engine starts, but helicopter will

not fly.

Helicopter takes off, but spins

rapidly and crashes.

Helicopter takes off, but banks

sharply and crashes.

Helicopter will not attach to pump.

Important Safety Information

Keep propeller clear from face, eyes and fingers. Do not launch

at people or animals.

Pay Attention: Make sure people around you know you are

playing with AIR HOGS

. Point helicopter away from face when

launching. Use only the pump included in this package. Other

pumps may damage the helicopter or lead to injury. Never

pump anything except air into the engine. Do not leave air in

the helicopter.

After your last flight, spin the propeller to make sure all the air

has been used up. Only use your AIR HOGS

helicopter in

grassy, open areas. To stop the propeller, gently touch the nose

cone to the grass.

Do not fly in very windy conditions. Do not fly

helicopter in

temperatures below 45˚F/7˚C or the wings will become brittle

and may break, and engine performance will decrease.

Do not fly near overhead wires.

Do not leave your Sky Commander

in direct sunlight and/or

extreme heat for excessive amounts of time.

IMPORTANT

1-800-622-8339

PLEASE DO NOT RETURN AIR HOGS® TO THE STORE.

CALL OUR FRIENDLY FLIGHT TECHNICIANS TOLL-FREE AT:

Asst#45049

Item# 45055, 45056

REV 0

ADULT SUPERVISION RECOMMENDED.

CAUSE

1. Pump up helicopter 50 times on an empty

tank to reach MAXIMUM air pressure

2. Remove dirt with a toothpick and re-pump.

3. After pumping is complete, spin the rotor

in the direction shown by the arrows to

start the engine.

1. On an empty tank, pump 50 times to

each for best performance.

2. Attach the Tail Wing to the helicopter

(see ASSEMBLY instructions above).

1. Be sure to slide the Tail Wing all the way

into the Tail Wing holder.Then, cover

both sides of the tail wing holder with

1. Always launch the helicopter by giving it

a gentle toss straight upwards.Tossing on

even a slight angle may cause the

helicopter’s flight to be unstable and

banking to occur.

1. Use a toothpick to gently remove debris.

1. No air in tank.

2. Air Intake on helicopter or Pump

Nozzle are clogged with dirt.

3. Rotor is not spinning.

1. Air Tank is not full.

2.Tail Wing is not attached.

1. Incorrect launching technique.

1. Air Intake on helicopter or Pump

Nozzle are clogged.

1.Tail Wing is not properly

assembled or has fallen off.

Air Hogs sky commander Assembly Instructions

Air Hogs sky commander Assembly Instructions

Air Hogs sky commander Assembly Instructions

Related papers

Other documents