Motorola HD-DTA100u Quick start guide

Type
Quick start guide
H D - DTA10 0 u
Quick Start Guide
Cable In
To TV
CH 3/4
Switch
HDMI
Power
The HD-DTA100u
will not turn on
• MakesurethePOWERLEDonthefrontoftheHD‑DTA100u
islitgreen.
• IftheHD‑DTA100uisconnectedtoaswitchedoutlet,make
suretheswitchisturnedon.Itisrecommendedtousean
unswitchedoutlet,ifpossible.
• UnplugtheHD‑DTA100ufromtheACoutlet,andthenplugit
backin.
• MakesuretheremotecontrolisinDTAmode,andturnthe
HD‑DTA100uonbypressingtheDTAbutton.
The remote
control does not
work
• MakesuretheremotecontrolisinDTAmode.
• Makesuretherearenoobstructionsbetweentheremote
controlandtheHD‑DTA100u.Aimtheremotecontroldirectly
attheHD‑DTA100ufrontpanel,nottheTVorVCR.
• TheanglebetweentheremotecontrolandtheHD‑DTA100u
maybetoolarge.StandinfrontoftheHD‑DTA100uandnot
toofartoeitherside.
• Pressandreleaseoperationbuttonsoneatatime,rmlyand
deliberately.
• Checkthebatteriesintheremotecontrol.Installnew
batteriesifneeded.
There is no video
on the TV screen
• MakesuretheTVisonandsettotheappropriateinput
sourcefortheHD‑DTA100u.
• MakesuretheHD‑DTA100uisonandtunedtoanauthorized
cablechannel.
• MakesurethecablesbetweentheHD‑DTA100uandtheTV
arermlyconnected.
• Makesurethecoaxialcablefeedisrmlyconnectedtothe
HD‑DTA100uandthewalljack.
There is no audio
when viewing
cable channels
• PressMUTEontheremotecontroltorestoresound.
No closed
captions display
• MakesureclosedcaptionsareenabledontheTV.(Note:
Closedcaptioningmaynotbeavailableforthecurrent
program.)
Troubleshooting
Checkherebeforecallingyourserviceprovider.
HDTV
HDMI
Coax cable
Power cord
HD-DTA100u
HDTV Electrical OutletCable Outlet
Cable In
+5V DC In
12 3
HDMI
HDMI
MOTOROLAandtheStylizedMLogoaretrademarksorregisteredtrademarksofMotorolaTrademarkHoldings,LLC.HDMI,
theHDMIlogo,andHigh‑DenitionMultimediaInterfacearetrademarksorregisteredtrademarksofHDMILicensing,LLC
intheUnitedStatesand/orothercountries.Allotherproductorservicenamesarethepropertyoftheirrespectiveowners.
Nopartofthispublicationmaybereproducedinanyformorbyanymeansorusedtomakeanyderivativework(suchas
translation,transformation,oradaptation)withoutwrittenpermissionfromMotorolaMobility,LLC.
©2012MotorolaMobility,LLC.Allrightsreserved.
589976‑001‑a09/12
SDTV
Coax cable
HD-DTA100u
SDTV Electrical OutletCable Outlet
Cable In/
RF In
To TVCable In
+5V DC In
12 3
Power cord
Setting Up Your HD-DTA100u and
RF4CE Remote Control
IMPORTANT! Read the enclosed Safety Instructions
before you begin.
1. Connect your cable service.
Connectthecoaxialcablefromyourwalloutlettothe
Cable InportontheHDDTA100u.
2. Connect your TV.
IfyouhaveahighdenitionTV,usetheHDMIconnector.
IfyouhaveastandarddenitionTV,usetheTo TV
connector.
3. Plug in the HD-DTA100u.
ConnectthepowercordtotheHDDTA100u,thenplugit
intoanunswitchedelectricaloutlet.
4. Turn on the TV and select the input.
IfyouhaveanHDTV,usetheremotecontrolforyour
TVtoselecttheHDMIportyouusedtoconnectthe
HD DTA100u.
IfyouhaveanSDTV,tuneyourTVtoChannel3and
settheswitchonthebackoftheHDDTA100uto
CH3.Ifyourscreenremainsblack,switchyourTVand
HDDTA100utoCH4.
5. Put the batteries in the HD-DTA100u remote
control.
6. Program the RF4CE remote control.
PointtheremotecontrolattheHDDTA100u.Pressand
holdtheSETUPbuttonuntiltheLEDontheremote
controlblinkstwice,thenpresstheMenubutton.The
LEDwillblinkcontinuouslyuntiltheremotecontrolis
paired.Followthepairinginstructionsonthescreen.
(Pairinginstructionsarealsoprintedonthebackofthe
remotecontrol.)
  • Page 1 1
  • Page 2 2

Motorola HD-DTA100u Quick start guide

Type
Quick start guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI