2. ICOM
  3. UT133

ICOM UT133 Installation guide

  • Hello! I've reviewed the user manual for the UT-133 Bluetooth Option Board. This document provides a step-by-step guide on how to install the board, including preparing with sponges and attaching it to the transceiver's PCB. I'm ready to assist with any questions you might have regarding the installation process or the features of this board.
  • What should be done before starting the installation?
    What needs to be removed to access the device?
    What is the purpose of the sponges?
UT-133 Bluetooth Option Board Installation
(Continued on the right above.)
Top cover
Sponge
(Thin)
Sponge
(Thick)
Sponge
(Thin)
Sponge
(Thin) Top view
Sponge
(Thick)
UT-133
Top view
Sponge
(Thick)
Top view
Before the installation:
Prepare 2 sponges that comes with the IC-A120.
1) Turn OFF the transceiver and disconect the DC
power cable from the power supply.
2) Remove the top cover.
3) Remove the protect sheet from the Thin sponge,
and then apply it to the PCB.
4) Remove the protection sheet from the thick sponge,
and then apply it to the UT-133.
5) Attach the UT-133 to the connector on the PCB.
6) Attach the top cover.
CAUTION! Optional unit installation should be done at an authorized Icom dealer or distributer.
Be careful of the top cover direction:
Cutouts
Rear
Front
/