Dryflow HDDFSEFOH-BRM Operating instructions

Type
Operating instructions

Dryflow HDDFSEFOH-BRM is a high-performance hand dryer designed for efficient and hygienic hand drying in various public and commercial settings. With its powerful 800W motor and air speed of 95m/s, it delivers a quick and thorough drying experience in just 10 seconds. The IPX4 ingress protection rating ensures safe operation even in humid environments, making it ideal for use in bathrooms, washrooms, and other high-traffic areas.

Dryflow HDDFSEFOH-BRM is a high-performance hand dryer designed for efficient and hygienic hand drying in various public and commercial settings. With its powerful 800W motor and air speed of 95m/s, it delivers a quick and thorough drying experience in just 10 seconds. The IPX4 ingress protection rating ensures safe operation even in humid environments, making it ideal for use in bathrooms, washrooms, and other high-traffic areas.

Steel Force Hand Dryer
Dryflow, 7 Riverside Court, Don Road, Sheffield, S9 2TJ. UK.
+44 (0)114 3540047 | [email protected] | www.dryflow.co.uk
Instructions
Thank you for your purchase. Please read these instructions before
installation and/or use and keep in a safe place for future reference
WARNING personal injury or accidents may occur if used Incorrectly MAINTENANCE
1. To clean the outer cover, please turn off the power to the hand dryer,
then use a damp soft cloth and a neutral detergent to wipe clean. Do not
use acid or alkaline based detergents like benzene, lacquer thinner. Avoid
the use of abrasives and nylon brushes as these may damage the cover.
2. When cleaning, the dripping of water onto the hand dryer must be
avoided to prevent electric shock or the hand dryer to short circuit.
3. It is advisable to switch off the hand dryers when not in prolonged use to
extend the units service life.
4. Only professional persons should disassemble, repair or modify the
hand dryer, or else this may cause electric shock, fire or other
accidents / injuries.
5. If a fault does occur with the unit, please make sure the power supply is
turned off as quickly as possible, stop using the machine and commission a
professional to make repairs.
TERMS OF GUARANTEE
1. The guarantee period comes into effect from the date of purchase,
please refer back to your invoice.
2. If a fault occurs within the guarantee period outlined at date of purchase,
please contact and provide proof of purchase to where you brought the
hand dryer.
3. The following are not included in the terms of guarantee:
- Improper use and/or the fault caused by disassembling, repair or
modification by anyone not authorised by the company you bought the
unit from.
- Faults and abnormal voltages caused by fires, earthquakes, lightening
and any other natural disaster.
- Faults caused by the use of non-matching power input.
- Faults caused by operation in poor working conditions or lack of routine
maintenance / servicing.
4. If a fault occurs outside the guarantee period, please do still contact the
place where you bought the hand dryer as they will be more than willing
to assist.
• Do not open the front panel, otherwise this may cause
an electric shock
• Ensure children are not allowed to play with the hand
dryer and are supervised at all times.
• Do not install the hand dryer too close to excessive
water sources such as bathtubs, showers and basins.
• Do not modify or disassemble the unit unnecessarily as
this may lead to fire, electric shock or personal injury.
• This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
• If the power cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid hazard.
• You must turn off the power before any maintenance
or servicing of the hand dryer takes place.
• The installation of leakage circuit breakers or other
protection is recommended to avoid fire hazards etc.
Prohibited
Do not place
near excessive
water sources
Disassembling
is prohibited
Please
comply
with all
instructions
INSTALLATION METHODS
HOW TO USE
TECHNICAL DATA
COMPONENTS
Switch Cover Power Switch
Key
Main Body
Installation Back Plate
Screws
Wall Plugs
Drain Tank
Filter
Rated Voltage
Rated Frequency
Rated Power
Motor Power
Weight
AC220-240V
AC110-127V
50/60HZ
1650W
800W
12KG
Ingress Protection
Heating Conditions
Air Speed
Drying Time
Overall Size (mm)
IPX4
Ambient Temperature
<25oC
95m/s
10s
300 x 222 x 730
INSTALLATION METHODS INSTALLATION METHODS
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Dryflow HDDFSEFOH-BRM Operating instructions

Type
Operating instructions

Dryflow HDDFSEFOH-BRM is a high-performance hand dryer designed for efficient and hygienic hand drying in various public and commercial settings. With its powerful 800W motor and air speed of 95m/s, it delivers a quick and thorough drying experience in just 10 seconds. The IPX4 ingress protection rating ensures safe operation even in humid environments, making it ideal for use in bathrooms, washrooms, and other high-traffic areas.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI