2. Eterna
  3. VECORDL6
VECORDL6

Eterna VECORDL6 User manual

  • Hello! I've reviewed the Eterna user manual for VECORDL6, VECORDL12, VECORDL18, and VECORDL24 LED Recessed Downlights. This document explains how professionals can replace the LED light source, detailing disassembly, soldering, and reassembly steps. I'm ready to answer any questions you have about the process.
  • What is the first step before replacing the light source?
    How do I release the LED Driver?
    What should I do with the connector leads?
Replace Light Source Products LED Recessed Downlights 1 of 1
VECORDL6 Light Source
VECORDL12 Replaceable by
VECORDL18 Professional
VECORDL24
1 2 3 4 5
a Unsolder Connector Lead
from LED Tape
b Resolder Connector Lead
onto new LED Tape
See Step 11 for Re-Positioning
6 7 8 9 10
11 12 13 14 15
Ensure Lead is position to fit into Rear
Cover Plate slot
Re-attach Rear Cover with fixing screws
Refit Springs
Reconnect Driver Lead
Reinstall Lumiinaire
Fitting must be removed from mains
power
Twist plug/socket anticlockwise to
release LED Driver
Remove Springs x2
Remove fixing screws to take off Rear
Cover
Lift out and remove Reflector assembly
Lift out and remove Light Guide Plate and
Diffuser
Diffuser removed - shows connector lead
and LED Tape
LED Tape can then be removed from
Body Casting
Lead will need to be unsoldered then
resoldered onto new Tape
Remove adhesive from LED Tape and
position tape in Body Casting
/