2. SUN GLOW
  3. Roller Shades

SUN GLOW Roller Shades Operating instructions

  • I have analyzed the Safety Shield Instructions document. The guide provides clear steps on how to install and operate the safety shield for roller shades. It emphasizes the necessity of having a fully installed roller shade before operating the shield, and the correct positioning of the safety shield tube after operating the shade. I'm here to answer any questions you have about the safety shield and its usage.
  • What should I do before installing the Safety Shield?
    How do I install the Safety Shield?
    How does the Safety Shield work?
Sun Glow Window Covering Products of Canada Ltd.
Manufacturer & Wholesale Distributor
Telephone: 416.266.3501 Toll Free: 800.668.1728
Fax: 416.266.5484 Toll Free: 877.245.9943
50 Hollinger Road, Toronto, Ontario M4B 3G5
www.mysunglow.com
02/05/2022
Page 1 of 1
Safety Shield
Instructions
STEP 1: PREPARING FOR INSTALL
Roller shade must be fully Installed and chain operational
before Safety Shield can be installed.
Refer to the different roller shade installation instructions.
STEP 2: INSTALLING THE SAFETY SHIELD
With #6 Screw provided fasten the Safety Shield to the inner wall of the window frame (Fig. 1 & 2). Ensure the
chain can move freely through the Safety Shield. The Safety Shield should be snug but not to tight against the wall
surface.
STEP 3: OPERATING THE SAFETY SHIELD
With one hand raise the Safety Shield tube up and operate the roller shade up or down (Fig. 3 & 4). When finished
operating, place the Safety Shield tube inside holder "The Safe Position" (Fig. 5).
Fig. 1
Fully
Installed
Fig. 2
1
Fig. 3
2
Fig. 4
Fig. 5
Shade
Moves Down
Shade
Moves Up
Safety Shield
Is In The Safe
Position
Open = 6" to 8”
/