Introduction
20W 100V Line Input
Instruction Manual
SG320 Outdoor Garden Speaker
Precision Design, absolute Confidence
Technical Specification
Installation Guide
www.ampereselectronics.com
SG320
Power rating
Power tapping (100V line)
Speaker diameter
Speaker type
Primary impedance
Frequency response
SPL (1w/m @ 1 kHz)
Construction material
Colour
Dimensions (mm)
Weight (kg)
20W 100V line
10 / 20W
5” (125mm)
Co - axial
1K / 500 Ohm
70Hz - 16 KHz
84 dB
Green
320 dia x 350 height (mm)
3.6 kg
ABS
SG320 is ideal for installation gardens, blend perfectly to the environment with its greenish
finishing and delivering high quality sound reproduction. Its housing is constructed using
outdoor resistance material which is subjected to intense heat and water splashing.
IP65
350 mm
290 mm
320 mm
Prepare the base for installation
Incoming Cable
Ground
Concrete / flat cement base.
Mount the speaker bracket
The bracket shall be mounted to the bone with 90° angle to each other.
90°
Terminate the incoming cable
Connect incoming cable to speaker with proper wattage required:
Yellow - Brown = 20W
Yellow - Blue = 10W
Speaker
Connector
Final speaker installation
Mount the speaker enclosure to the bracket using stainless steel screws.
Holes to mount base to
the bracket
Seal the connection with approriate tape / sealant
to avoid corrosion.
330 mm min
Height
The base shall be flat with minimum dimensions shown. It can be installed anywhere
in the garden area including shallow flood prone area.
Stainless steel screw
Base
140 mm
Screw
Base
Base
/
