Figure 3. End frame and center frame attached
to workbench top.
x 2
x 1
End Frame
Center
Frame
End of
Workbench Top
Figure 4. Upper support attached to workbench.
x 1
Upper
Support
Side of
Workbench
Top
Figure 5. End frame and upper support secured
together with corner braces.
x 3
End Frame
Upper
Support
External
Corner Brace
Internal
Corner
Brace
-2-
Model T31832 (Mfd. Since 01/20)
Assembly
To assemble the workbench stand:
1.
Lay workbench top upside-down on a pro-
tected surface, such as cardboard or a
blanket.
2.
Attach both end frames and center frame to
workbench top with (4) M8-1.25 x 55 button
head cap screw and (4) 8mm flat washer (see
Figure 3). DO NOT fully tighten fasteners at
this time.
3.
Attach each upper support to work-
bench top with (1) M8-1.25 x 55 button
head cap screw and (1) 8mm flat wash-
er (see Figure 4). DO NOT fully tighten
fasteners at this time.
4.
Secure end frames and upper supports with
(4) external corner braces and (4) internal
corner braces, using (3) M8-1.25 x 55 button
head cap screws, (6) 8mm flat washers, and
(3) M8-1.25 lock nuts for each corner (see
Figure 5). DO NOT fully tighten fasteners at
this time.
5.
Secure center frame and upper supports
with (1) support brace and (4) internal corner
braces, using (8) M8-1.25 x 55 button head
cap screws, (16) 8mm flat washers, and (6)
M8-1.25 lock nuts (see Figure 6). DO NOT
fully tighten fasteners at this time.
The Model T31832 Workbench Stand can be used
with many different types of solid wood work-
bench tops, but it is best paired with the Grizzly
Model T1254 Beech Workbench Top, which has
threaded mounting holes located specifically for
mounting the T31832 frame.
— If you are using a Grizzly Model T1254
Beech Workbench Top, proceed to Step
1.
— If you choose to use your own workbench
top, complete Steps 4–7 BEFORE per-
forming Steps 1–3. Proceed to Step 8
once all previous steps are completed.